Question about 1994 GMC Sierra

1 Answer

Engine idle high when taking off - 1994 GMC Sierra

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 54 Answers

Not sure what you are asking the truck should idle high on take off.

Posted on Jun 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Jeep cold start heater location


It likely has EFI (electronic fuel injection) and an idle air control valve that regulate idle speed. They can get gummed and fail to have a fast idle when cold, or get stuck the other way, and have a too fast idle all the or regularly take its time slowing down after you take your foot off the gas. An engine temp sensor can also cause a lingering high idle if it reports the engine as still being cold after warm up.

Aug 15, 2014 | 1996 Jeep Grand Cherokee

1 Answer

Starting car idle is very high


sounds like your air intake gasket is leaking. If you take ether, or brake cleaner and spray it where the air intake is bolted on, the idle will come down to normal. Is this problem existing even after the engine is warmed up, or just when you first start it up?

Apr 11, 2014 | 2001 Chrysler 300M

1 Answer

Idle problem integra


check the MAP sensor (manifold absolute pressure). The ECM (car computer) uses that to keep idle at minimum 750 RPM. It's normal for it to run high when cold. These small 4 banger motors typically run hot, and they won't run right IF they're NOT running hot, ergo the idle is usually high when it is cold so as to cause it to warm up quicker. If the RPM's drop below 750, suspect the MAP sensor, &/or ECM.

Apr 18, 2013 | 1995 Acura Integra Coupe

3 Answers

What is high idle?


When a car is idling it is at rest.The idle setting refers to the engine revolutions or 'revs'.If the setting is increased so that the 'revs' are greater,the engine will not stall at rest.This is 'high idle'!

May 16, 2012 | Cars & Trucks

1 Answer

1992 legend, 170,000. miles check engine light on idles to high


This could be a lot of different reasons. Take to Auto Zone for a free diagnosis check.

Dec 04, 2009 | 1992 Acura Legend

1 Answer

High idle speed when the engine is cold


The high idle speed at start up is normal. As the engine temperature increases, the engine idle should kick down automatically. Insofar as the emissions results, if there were a problem, the check engine light should be on. If it is, take the car to an autoparts store and have the fault codes read. Most parts stores will perform the scan for free. If the check engine light is not on, and the idle question was all you were worried about, you are good to go! Hope this helped and best wishes.

Jul 31, 2009 | 2002 Toyota Camry

1 Answer

Carburator tune up of charadade 1992 sedan. The engine is running too fast while idle at 1200 r.p.m.


Before you start check the status of your choke. One that is stuck on will cause a high idle. If the choke checks out, proceed to the following:


You should have what's called a 2 needle carburetor. A larger screw adjustment for idle, and a smaller for high speed.

Start by adjusting your low speed (idle) needle until you reach the desired idle. I prefer about 850rpms. Do this with the engine running and adequately warmed so that your adjustments are not thrown off by the automatic choke.

Next slowly open up the high speed needle. As you open it your idle speed will gradually increase. Adust it in 1/8 turn increments, pausing after each adjustment to allow the changes to take affect. Keep opening it until you stop increasing your rpms, then take it back 1/8 of a turn.

Next readjust your idle mixture screw so that your idle is back down to 850rpms.

Apr 29, 2009 | 1992 Daihatsu Charade

1 Answer

Engine codes p1133 p0171 p0507 p0131 all at once


Per your description, it sounds like you have a vacuum leak.
Check all vacuum hoses at the engine, make sure no hoses are disconnected, cracked or damaged.
Disconnect each hose at the source on the engine and see if the engine idle stabilizes.
Let me know what you find and we can go from there.
Regards.

Mar 10, 2009 | 2002 Pontiac Sunfire

1 Answer

Idling to high


Hi jmach,

There is nothing wrong with your vehicle and no need to have anything repaired.... The high idle speed is controlled by the on board ECU...(the Electronic Control Unit).... When starting the vehicle from cold, the automatic enrichment of fuel increases the idle speed... Depending on the ambient air temperature.... the colder the weather, the longer the engine will take longer to return to normal idle speed. Thats how it's designed to operate.

Regards Johngee10

Jul 12, 2008 | 2004 Toyota Matrix

Not finding what you are looking for?
1994 GMC Sierra Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...