Question about 2003 GMC Sierra

Open Question

2003 GMC Sierra Drivers side power window and mirror are not

Drivers side power window and mirror are not working. Is this the switch or the window motor? Does the widow motor operate the power mirror? Any ideas?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
TheValley
  • 6 Answers

SOURCE: 4X4 inop on 2003 GMC Sierra 2500HD

I have found that when you are going to engauge 4x4 high, it is best to only be going about 3 miles an hour. Not faster, not stopped. It likes some movement to help it mesh. I've had perfect shifts since I started this. Hope it helps. Wade.

Posted on Jan 27, 2009

Ad
  • 2 Answers

SOURCE: HAVE A 03 GMC SIERRA

I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.

Posted on Dec 21, 2008

  • 2 Answers

SOURCE: 2003 Sierra rearview mirror

replace outside sensor

Posted on Feb 28, 2009

raffaiel
  • 209 Answers

SOURCE: Loose side mirror. Need to tighten it up.

just remove the panel inside at the side of the mirror, then you will find the bolts.

Posted on Apr 25, 2009

  • 3600 Answers

SOURCE: where is the wiper motor on a 2003 gmc sierra

Replace the multifunction switch where the wiper switch and turn signal are located on the steering wheel. There are two screws that hold it on and you can remove the cover on the steering wheel with a tork wrench #6 I think, could be next size down #4 then remove the two screws holding the switch in place. And disconnect the wiring Replace the multifunction switch where the wiper switch and turn signal are located on the steering wheel. There are two screws that hold it on and you can remove the cover on the steering wheel with a tork wrench #6 I think, could be next size down #4 then remove the two screws holding the switch in place. And disconnect the wiring connector and replace. connector and replace. If you need more help post here and Thanks for using Fix-ya.

Posted on Aug 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could cause my power windows not to work?


Usually it is in the drivers window controller.There is a module that usually goes bad.

Dec 14, 2014 | Cars & Trucks

1 Answer

Why doesn't my 2000 chevy blazer power windows and door locks and remote mirror doesnt work. Power window on passenger side does work


well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!

May 04, 2014 | 2000 Chevrolet Blazer

1 Answer

Side mirrors do not operate


5A fuse 4 in the smart junction box supplies power to the mirror adjustment switch.

Jan 19, 2014 | Cars & Trucks

1 Answer

Window switch


loose fuse, or weak fuse (micro cracks) or bad wires , bad connectors
it can only be 3 things, power fuse, wires, switch or motor.
cant be motor as you are doing them all.

Nov 07, 2013 | 1999 Acura TL

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere


First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

1 Answer

I'm trying to find the fuse that works the rear windows


The front and rear windows operate on the same circut.Try all the switches ,master on the drivers door and each rear door.The switches reverse the polartity to operate up and down. If the switches are OK, then tast for power at the widow motor behind the door panel

Feb 28, 2011 | 1999 Toyota Corolla

3 Answers

1995 jaguar driver seat won't move.


You might want to try disconnecting the negative battery cable for 5 minutes and then reconnecting it. This procedure fixed my seat that was not working. It works fine now. I know it sounds too good to be true but it usually works

Jan 23, 2010 | 1995 Jaguar XJ6

1 Answer

Drivers window not woring


These driver widow motors are fairly simple. You must have power on one wire and ground the other to make it work. Reverse the polarity and the motor operates in the reverse direction. If you have power on the black wire make sure you have a ground path on the blue and vice versa when you operate the switch in the other direction. There is a possiblity you may have a broke ground wire between the cab and the door causing all the problem.

Nov 07, 2009 | 2006 Chevrolet Equinox

1 Answer

Drivers side window control not working


My opinion it is that it is, in fact, the driver's door switch panel and you should try replacing it (try EBay). The problem could ether be worn out switches, or there is a problem with the distribution of power to all the switches in the panel. You should be able to easily diagnose the problem by pulling the switch panel (without removing the door panel) and checking switched power at each switch at the back with a multimeter.

Seat heating pads are built to flex but are a bit flimsy. As they get older and have been sat on many times, the element wiring can break in the weakest spot causing the problem. Unfortunately, to check out the wiring, you usually have to remove the seat.

Sep 19, 2017 | 1998 Cadillac Eldorado

Not finding what you are looking for?
2003 GMC Sierra Logo

Related Topics:

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...