SOURCE: 1984 corvette fuel solenoid
unfortunatly you are going to have to run new power and a new pump. a fuel injection pump runs 30 psi minimum some of them quite a lot higher than that. a carb cannot have more than 7psi without bypassing the float in it and overflowing the carb with fuel. when going to a carb you will have to get a low pressure fuel pump and completely rerun the fuel system
SOURCE: INSTRUCTIONS TO INSTALL FUEL PUMP ON 1989 CORVETTE
REMOVAL
INSTALLATION
SOURCE: trying to locate fuel pump relay for 1991 corvette- coupe
The fuel pump relay in the 1991 corvette is located under the IP on the pass side.
Open pass door, unscrew two screws under the glovebox (you will be upside down in the car), take off the fuse panel, unscrew third screw to plastic plate underneath glovebox, pull away carpet (velcro), pull down plastic plate (watch out for the wiring to the lamp), then under the glovebox you will find a number of fuses and relays if you dive in under there DEEP, prob 4 or 5 in a row, not really sure wich one, but one in the middle is the fuel relay, and they are the same (interchangable).
Take a look at --the12volt.com/relays/relays.asp--
It´s those relays we are talking about.
525 views
Usually answered in minutes!
×