Question about 2004 Ford Focus

Open Question

2001 FORD FOCUS ZX3 HAS NO LOW BEAM LITES

HAVE HIGH BEAMS NO LOW. HAVE REPLACED THE RELAY AND CHECKED ALL FUSES NO GO.

ANY IDEAS?

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Both low beam headlights are out.


check for voltage at the high beam switch when high beams are turned on.

Oct 08, 2012 | 2004 Ford Focus

2 Answers

2005 Ford Focus ZX3 SES, the blue high beam indicator in the dash comes on with low beams, and goes off with high beams. The indicator is on at the wrong time! I have tried the following: The turn signal...


It sounds like you are confused about how your headlamp system is supposed to work. The DRL does not run on the High beam circuit, it runs on the low beam circuit. The fog lamps are supposed operate with the park lamps and also with the low beams, not the high beams. From your description, I would say that your system is operating as designed and you are having trouble telling High from Low. (Don't feel bad, that is why high beam indicators were invented in the first place.)

May 08, 2011 | 2005 Ford Focus

2 Answers

Headlights do not work. Beam works, park lights and other lights work. Bulbs ok


more than likely a fuse or a relay is bad. locate the fuse for the headlights (owners manual) and check if it is bad, if the fuse is good, find the relay and give it a flick or two and try the headlights then, if they work, its time for a new relay

Mar 19, 2011 | 2006 Ford Focus

3 Answers

Low beam head lights not working - The low beams, both stopped working. The high beams work fine. I checked the fuses and all 4 are good. I even swapped the low and high beam fises just in case. No...


if the fuses are good then you need to check for power and ground at the headlight plug that attaches to the headlight bulb if you have a good power and ground there and the connections are good then the bulbs are both no good.or if you can tell the bulbs are burnt out by looking at them then you don`t have to check powers and grounds.you also can directly feed power and ground to the bulb and check both the terminals for high beam and low beam as you cannot tell which is which by looking at the terminals

Mar 04, 2011 | 2001 Ford Focus

2 Answers

How to replace a 2001 ford focus headlight switch assembly


p, li { white-space: pre-wrap; }

Turn the engine off, open the hood, and disconnect the negative battery cable (--) with your pliers.



Locate the power distribution box against the firewall on the driver's side of the engine compartment. Flip up the latch and remove the plastic cover.



Determine which headlight fuse you want to replace. The 2001 Ford Focus uses four headlight fuses--one for each headlight. Fuse number 16 is for the passenger side low beam; fuse number 17 is for the driver's side low beam. Fuse number 26 is for the passenger side high beam; fuse number 27 is for the driver's side high beam.



Grasp the fuse with your fingers and pull it straight out of its mount. Insert the new fuse in its place. Replace the plastic cover and reconnect the negative battery cable.

Sep 26, 2010 | 2001 Ford Focus

1 Answer

Low beam headlamps wont turn on change bulbs and checked fuses and still wont come on.


did you check for a relay in your fuse panel? there should be a relay that controls your low beams and one for your high beams. check for that and then if high beams are working swap it with low beam relay. if your problem switches to low beams working and high beams not working replace the bad relay.

Jan 26, 2010 | 1998 Ford Explorer

1 Answer

2001 Ford Focus - High beam / low beam problem with headlights


just replace the dimmer switch under the column its wore out on the low beam side

Jan 17, 2010 | 2005 Ford Focus

1 Answer

No low beam both sides have high beams all


sounds like the wires are crossed try changing the bulbs use a set from the auto recyclers if you go to the recyclers take some paper towel and wrap them up b4 you stick them in your pockets

Jan 03, 2010 | Ford Focus Cars & Trucks

2 Answers

High beams are stuck on..


maybe your wire instalation is wrong

Nov 08, 2009 | 2001 Ford Focus

1 Answer

Ihave no low beams


The light bulbs may need to be replaced, they burnt out on the low beam only.

Jun 28, 2009 | 2001 Ford Focus

Not finding what you are looking for?
2004 Ford Focus Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...