1995 Isuzu Rodeo Logo

Related Topics:

A
Anonymous Posted on Jul 07, 2014

Where is the temperature sending swich on a 1995.5 Isuzu Rodeo

1 Answer

_-__-___-_

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Isuzu Master 20,706 Answers
  • Posted on Aug 01, 2014
_-__-___-_
Isuzu Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 06, 2013
Answers
20706
Questions
2
Helped
6802000
Points
57965

What dont work right, must we guess that?
and all Temperatature sensors, of the 6 or more?
tranny ?
EFI engine , ECT sensors
A/C overheat sensors
FAN cut in switches.>
or?

we car clueless until you provide some context., a symptom or ?

5 Related Answers

Anonymous

  • 33 Answers
  • Posted on Mar 27, 2009

SOURCE: firing order 1995 isuzu rodeo 3.2v6

123456 IS THE FIRING ORDER... RIGHT BANK (RIGHT AS IN SITTING IN THE DRIVERS SEAT NOT STANDING IN FRONT OF THE CAR)STARTING AT FRONT IS CYLINDER 1 THEN 3 THEN 5 THEN THE LEFT BANK IS CYLINDER 2,4,6, FRONT TO REAR... THE COILS FROM LEFT TO RIGHT (STANDING IN FRONT OF CAR) ARE 1,4,6,3,2,5 HOPE THIS HELPS

Ad

Lee M

  • 4 Answers
  • Posted on Sep 20, 2009

SOURCE: Where is the obd port

d2610cc.jpg
Here is a photo of the obd connector on a 1993 Isuzu Trooper.

The connector is on the transmission hump about 6 inches from the accelerator pedal. It is inside a black hood. Right next to the white OBD connector is an identical green connector that I have not tested.

The OBD port is a white 3 hole plug. Right next to it in the photo is a green 3 hole plug that I believe is for automatic transmission diagnostics. The plug is different from other plugs under the dash as it will not accept a .25" tab connector.

The picture shows a 20 ohm resistor being used to short pin 1 and 3 of the white plug. The resistor is to prevent a melted wire in case the plug shorted is the wrong plug.

To read the error codes from the engine computer, the mechanic is supposed to short pin 1 and pin 3 of the OBD port plug. Then the mechanic turns on the ignition switch and counts flashes of the "check engine" light to determine the error values being reported.

Anonymous

  • 1 Answer
  • Posted on Dec 16, 2009

SOURCE: where is the fuel filter on 1995 Isuzu Rodeo

should be under the passenger side rear door on the frame rail

Anonymous

  • 720 Answers
  • Posted on Jan 27, 2010

SOURCE: what is the oil capacity for a 1995 isuzu rodeo

Hiya,

As you have not specified engine size, i'll give you both capacities.

Oil Capacity for 1995 Rodeo, is:

2.6L Engine - 5.8 qts (with oil filter)
3.2L Engine - 6.2 qts (with oil filter)

Cheers,

"If this has helped you, please rate this solution"

Patrick Rayome

  • 1757 Answers
  • Posted on Feb 27, 2010

SOURCE: I need to find a diagram for a timing belt for a 1995 Isuzu Rodeo

We are talking about the Timing Belt and not the Drive/Surpentine Belt?

For the Timing Belt: CLICK on the following Link. It has all the Diagrams you will need for the Timing Belt.
http://www.2carpros.com/car_repair_information/year/1983/make/isuzu/model/pickup/1983_isuzu_pickup_timing_belt_diagram_marks.htm

For the Drive/Surpentine Belt: CLICK on the following Link. It has all the Diagrams you will need for the Drive/Surpentine Belt.
http://www.2carpros.com/car_repair_information/year/1995/make/isuzu/model/rodeo/1995_isuzu_rodeo_drive_belt_routing_diagram.htm

Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have an Isuzu Rodeo 1995 4cil that have problems with the gas, do not turn on, and I think that do not past the electric message to the gas. What I should do?

Fuel pump relay possible but i would have someone crank it for you while you bang on bottom of fuel tank. If it starts fuel pump is failing
0helpful
1answer

1995 Isuzu rodeo flasher wiring I HAD 5 WIRES

they sold you the wrong one take it back
1helpful
1answer

Where is the thermomter located on a 1995 Isuzu Rodeo?

Your question needs some clarification ,do you mean the temperature sender unit or are you looking for the thermostat. Regards ray.
0helpful
1answer
0helpful
1answer

1995 isuzu rodeo failed hc ppm during emission test, why?

The reasons are very numerous, a common one is dirty oil and a thermostat that is not getting the engine up to the correct operating temperature of about 200F. A worn out catalytic converter can cause this as well.
1helpful
1answer

Locationing temp sensor on 95 rodeo 3.2

There are SEVERAL temperature sensors on your vehicle (battery temperature sensor, intake air temperature sensor, evaporator temperature sensor, etc....you really should specify.

I will assume you mean the Engine Coolant Temperature (ECT) sensor.
If this is the one you are looking for, it is located at the rear of the intake manifold on the left side.
0helpful
1answer

Replace the timeing belt on1995 isuzu rodeo

I have instructions in .pdf that you can view on your computer. Send me your email with the subject TIMING BELT and I'll be happy to forward it to you.

[email protected]
0helpful
1answer

Firing order for 1995 isuze rodeo

1995 Isuzu Rodeo 3.2 liter SOHC V-6 (6VD1)

8e01b6e.gif


1995 Isuzu Rodeo 2.6 liter SOHC L4 (4ZE1)

5528056.gif

Hope helps (remember rated and comment this).
0helpful
1answer

I have a 1995 isuzu pickup it giving me error codes 15 and 34 and I've already been to 3 repair shops and can't get it fixed can you give me some help

I have the manual for my 93 rodeo and code 15 says ENGINE COOLANT TEMPERATURE SENSOR-SENSOR SIGNAL SHORTED, GROUNDED OR OUT OF RANGE. Check your coolant sensor by the water neck-it sends a signal to your dash gauge (coolant temp)
Code 34 my book has 2 symptoms- if its a 3.1 liter engine it says MAP SENSOR-SIGNAL VOLTAGE LOW-CHECK INCORRECT IDLE SPEED, VACUUM LEAKS, LOOSE AIR DUCT, MAP SENSOR CIRCUIT
If its NOT a 3.1 liter engine, then code 34 is EGR TEMPERATURE SENSOR CIRCUIT-SHORTED

Hope this helps.
1helpful
1answer

Help replacing radiator support 1995 Isuzu Rodeo

chiltons from any parts store or haynes manual will help you out alot
Not finding what you are looking for?

111 views

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...