SOURCE: how do I replace a fan belt on C280 model with air conditioner
You find a 17 mm bolt under the belt or a 15 mm bolt in the middle of the tension pulley. If you undo the bolat this will
release the belt tension.
To remove the belt turn the bolt by slipping a 4' pipe
over the socket wrench handle.
Use a wrench as a lever to slide out the belt. Put the new belt last on the idler pulley that contacts the belt only on the smooth
side.
Do not unscrew the Button Torx bolt in the center of the tension pulley, it is not needed.
SOURCE: 1998 Mercedes C280 2 Sensor gone bad. Where are the sensors...
sensor located in the exhaust system somewhere they just unscrew to remove
SOURCE: how do you time a 1995 Mercedes C280 inline 6 cyl?
hi,pls. remove the cylinder head cover,try to rotate the crankshaft on ot position,then look the hole 5mm in intake and exhaust sprocket,install 2 pcs. of 5mm pin with align on surface of cylinder head,ot on crankshaft pulley and two sprocket lock in the surface of head ,you have a104.941 engine,ty
SOURCE: I have a 1996 Mercedes-Benz C280. My turn signals
hello,good day,hoping your fuse is in order,may check your fuse in engine room,if ok,better to send your car to your dealer,because signal light and wiper system is connected to a control module,to avoid parts replacement not deffective,ty
90 views
Usually answered in minutes!
×