Question about 2005 Jeep Grand Cherokee

1 Answer

Cannot find proper fuse for radio - 2005 Jeep Grand Cherokee

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

What do you mean by cannot find & proper fuse? Do you mean the location of said fuse or type of said fuse?

In any case, grab your 2005 Jeep Grand Cherokee owners manual and refer to page 345; Turn the vheicle off and remove the keys from the ignition, as a matter of fact, you may even consider removing the negative lead from the vehicles battery before you go any further

Go to a Chrysler dealer or any automotive parts supplier and seek out a replacement 30AMP (Pink) fuse for your vehicle, it may not be a bad idea just to get a kit of different amperages so that you at least have them for future needs

To access the fuse panel under the dash - Tilt your steering wheel to the top most position and lock it - just below the steering wheel's lock lever, you'll see a section of trim that streches about 12" long with what appears to be a flat shelf like section on the top partion of it (just under the the steering lock lever) - Gently grasp this part with your Right hand fingers on the shelf and your right hand thumb below it and pull straight down to reveal the fuse block just on the left hand top of the area you just exposed - Using your manual, locate the 30AMP (Pink) fuse in cavity one and use and appropriate removal tool the pull it straight out from the block (if there's no fuse puller provided within the fuse block, you can use a set of smaller needle nose plyers, just be sure that you do not squeeze the hadles of the plyers too tight or the fuse will crack and break causing the fuse to potentially be stuck in the block) - inspect the fuse to determine that it is blown, a solid V or U shaped connecter from one post to the other say's that's not your issue but a break in the fuse only tells you that the fuse itself has blown, it does not tell you what caused the short that blew it, replace the fuse with the new one and clean up - Reconnect your batter (If you disconnected it) and turn the key to the ACC poosition then turn on your radio to test it - If it blows again, take it to the dealer, you have other problems that could potentially lead to a fire at the very worst

Hope this helps

Posted on Aug 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I replace the radio fuse in a 2004 mountaineer?


The radio has failed or is not wired properly. Is it aftermarket or original?

Jun 23, 2017 | Cars & Trucks

1 Answer

Radio will not come on no lights fuses look good 03 silverado


factory or aftermarket radio? I really cant help much on factory, if its aftermarket check your power and ground wires have good connection and in proper places, also check fuse on the back of your stereo

Mar 22, 2014 | 2003 Chevrolet Silverado 1500

1 Answer

Activate radio


MIGHT HAVE BLOWN FUSE OR WIRES NOT CONNECTING PROPERLY CHEK ALL CONNECTIONS AND FUSES//DOES LIGHT ON RADIO COME ON AT ALL????

May 25, 2013 | Holden VT Cars & Trucks

2 Answers

Radio display not working


You have locked the radio, you need to contact the dealer for assistance to unlock it.

Aug 09, 2012 | 2008 Honda Civic

1 Answer

I have a 2002 Chevy Malibu, and I somehow blew the fuse for the horn and the radio will not turn on or doors won't ding. Checked the fuse boxes..found the blown fuse for the radio and replaced it and the...


Check your owners manual for the location of a SECOND radio fuse. There are usually TWO fuses for the radio. One is the for the circuit to operate the radio when the ignition switch is turned on, the other is when the switch is off. The second one provides power to the radio when the key is off. It keeps the clock running and your radio presets. The radio requires BOTH fuses to operate properly.

Good Luck . . .

May 01, 2011 | 2002 Chevrolet Malibu

1 Answer

My car horn is stuck on (very loud) and I removed the fuse for the horn, but now my radio or interior lights dont work. What do i do?


Hello,

was the radio and interior light working before you removed the fuse for the horn? In the process of removing the fuse for the horn, you must have mistakenly tempered with the fuse for the radio and interior light.

So I would suggest you go back to the fuse box and deep them in properly because the interior and radio fuse might not be contacting properly.

I hope this makes sense to you.

Good luck.

Nov 29, 2010 | 1993 Toyota Camry V6

1 Answer

The radio in my 2000 beetle will not turn on. i can't seem to find the proper fuse in the in cabin fuse panel. is the a backup fuse under the hood?


hi,
there should be 2 fuses directly relating to the radio.
first is a 25 amp fuse for audio system, fuse box on drivers side of dash, number 42.
second is a 10 amp fuse directly in the back of the radio, which you'll need pins to remove.

Jul 28, 2010 | 2000 Volkswagen Beetle

1 Answer

Radio comes but no sound. Radio seems to be working and the connections are ok. Fuses are ok.


if you dont get even a pop or crack when turned on at first, check the radios memory on the read-out on the radio face and see if its on mute setting, and if this is not the case, there are 2 fuses,one controls memory power and the other controls audio output power, check both as if one fuse is out the other cant make the radio operate properly

Dec 08, 2009 | 2002 Chevrolet Tahoe

3 Answers

Saab radio no power


Saab 2002 9-5 Saab radio no power

Nov 23, 2009 | 2002 Saab 9-5

1 Answer

Was in SAFE mode now screen is blank


bad ground or bad power source behind radio and radios sometimes has fuse to the back of radio
something might have surged the cars electrics

some vehicles come with 3 fuses for radios sometimes more
these fuses are listed as
fuse box
power wire fuse box this will be located on the power wire to radio
and then you have the radio fuse

some radios have what they call an antitheft shutdown if the code was not properly put in after so many times the radio completly shuts off or for a length of time it will also shut down the radio

recommendation take vehicle to dealer so they can show and reapply code for you to you then you would never forget how to do it

Jun 11, 2008 | 1994 Volkswagen Jetta

Not finding what you are looking for?
2005 Jeep Grand Cherokee Logo

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...