Question about 1985 Chevrolet S-10

2 Answers

Where's the computer located on a 1985 chevy s10 pickup

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers

Hi..my name is Keith..and the computer(ECM)..is an aluminum box located in the engine compartment..either mounted to a fender or on the firewall..i hope this helps

Posted on Jun 28, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,984 Answers

  1. Make sure the ignition is turned OFF, then disconnect the negative battery cable.
  2. Locate the computer control module. If not readily visible on the right side of the engine compartment, it is probably mounted under the dash.
where's the computer located on a 1985 chevy s10 - a3a585c.gif

Posted on Jun 28, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 218 Answers

SOURCE: will a 1985 S10 blazer tilt steering collum fit a

yepper! lol i have owed 5 of this geneation and both the s-10 and blazer are identical in the dash, engin and drive train

Posted on Jun 06, 2010

  • 1596 Answers

SOURCE: I need to replace the fuel pump in my 1985 Chevy S10 Pickup.

EXACT PROCEDURE ! Please Rate Me Fairly for this!! Thank you And Good Luck !!


ELECTRIC PUMP

REMOVAL

  1. Before servicing the fuel pump the fuel system pressure must be relieved. See: Fuel Pressure Release
  2. Disconnect the negative battery cable.
  3. Raise the car on a hoist.
  4. Remove the fuel tank. See Fuel Tank / Service and Repair.
  5. Remove the fuel tank sending unit and pump assembly by turning the cam lock ring counterclockwise. Lift assembly from the fuel tank.
  6. Pull the fuel pump up into the attaching hose while pulling outward away from the bottom support. Take care to prevent damage to the rubber insulator and strainer during removal. After the pump assembly is clear of the bottom support, pull the pump assembly out of the rubber connector for removal. NOTE: Inspect the fuel pump attaching hose for any signs of deterioration. Also check the rubber sound insulator at the bottom of the pump. Replace damaged or deteriorated parts.
INSTALLATION
  1. Push the fuel pump assembly into the attaching hose.
  2. Position the fuel tank sending unit and pump assembly into the fuel tank. Use a new "O" ring seal. NOTE: Care should be taken not to fold over or twist the strainer when installing the sending unit as this will restrict the flow of fuel. Also, verify that the strainer does not block the full travel of the float arm.
  3. Install cam lock over the assembly and lock by turning clockwise.
  4. Reinstall fuel tank.
MECHANICAL PUMP

REMOVAL and INSTALLATION

NOTE: To ease pump installation, rotate the camshaft so the camshaft eccentric is out of the way of the fuel pump rocker arm.

  1. Disconnect fuel lines from fuel pump.
  2. Remove fuel pump mounting bolts and the fuel pump.
  3. Remove all gasket material from the pump and block gasket surfaces. Apply sealer to both sides of new gasket.
  4. Position gasket on pump flange and hold pump in position against its mounting surface. Make sure rocker arm is riding on camshaft eccentric.
  5. Press pump tight against its mounting. Install retaining screws and tighten them alternately.
  6. Connect fuel lines. Then operate engine and check for leaks.

Posted on Mar 22, 2009

  • 79 Answers

SOURCE: fuel pump on 1985 chevrolet blazer s10 location..where is it??

gas tank

Posted on Mar 22, 2009

jeffbvegas1
  • 520 Answers

SOURCE: where's the computer located on a 1985 chevy s10 pickup

look in the interior passenger side kick panel in front of the door where the panel and carpeting meet

Posted on Jun 28, 2009

ftw1952
  • 10319 Answers

SOURCE: where is the map sensor located on 1985 s10 pickup 2.8 liter v6

it has one vacuum line to it and its half the size of a pack of cigarettes. Look around the intake area

Posted on Jan 10, 2010

Testimonial: "i thank you very much for your answer because i am disabled and need all the help i can get thank you very very much"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do I have to take the dash out to replace the heater core on a chevy s10 pickup?


google "how to replace the heater core on a chevy s10 pickup"
and it will come up with lots of video and text on how to do this

Nov 19, 2014 | Chevrolet S 10 Cars & Trucks

1 Answer

How do I find the blower resistor on a 2000 chevy S10 pickup


Here's what it look's like,it's located next to blower motor,remove electrical connector and two screws and ala,it's off.

Jan 31, 2013 | Cars & Trucks

1 Answer

I have a 1985 chevy s10 2.5 pickup that wont run right


Is the exhaust converter worn out,damaged & fails inspection?
eg: Exhaust Blocked

Timing Belt etc?

Jun 02, 2012 | 1985 Chevrolet S-10

1 Answer

Where is the map sensor located on 1985 s10 pickup 2.8 liter v6


it has one vacuum line to it and its half the size of a pack of cigarettes. Look around the intake area

Jan 09, 2010 | 1985 Chevrolet S-10

1 Answer

1997 Chevy S10 pickup Fan switch for heater runs on high only.


replace the blower motor resistor located on the heater box were the blower motor is located the wiring to the blower may go to it. This is very easy to locate if you buy the part first.

Jan 06, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

Where's the computer located on a 1985 chevy s10 pickup


look in the interior passenger side kick panel in front of the door where the panel and carpeting meet

Jun 28, 2009 | 1985 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

1,129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...