Question about 1994 Buick Skylark

1 Answer

I just put a brand new battery in my 1994 buick skylark and now the volts light is on...Could this be an alternator problem?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 218 Answers

Hi,,my name is Keith..and i would say..99% of the time..its the alternator that needs to be replaced...when the voltage light is on..i hope this helps

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The running lights and tail lights work but no headlights on my 1994 Buick Skylark Custom. What is wrong?


Hey Dan , do you have a volt meter ? Pull head lamp bulb , with lights on check for battery voltage on tan wire left headlamp an lite green right side headlamp ! If there is no voltage back track to headlamp switch , which means pulling the plastic cover from around the upper steering column ! check for battery voltage at the Orange wire in connector # 1 , that is voltage supply to the headlamp switch ! Power going in an no power coming out with the switch in the headlamps on position means your switch is bad !

Apr 02, 2015 | 1994 Buick Skylark

1 Answer

Battery not charging


1) You must do some easy proofing Run the car and take out the positive terminal, if the car motor goes out, the generator is faulty.
2) See the diagram attached. God bless you

5_22_2012_10_19_36_am.jpg5_22_2012_10_20_02_am.jpg5_22_2012_10_20_55_am.gif

May 21, 2012 | 1994 Buick Skylark

1 Answer

The car will not run and when i turn the ignition it only clicks. I tried jump starting it but it won't do anything. When i turn the lights on their powerful and not dim a t all i bought a new battery two...


You are going to have to put a new battery in, or charge the battery in it now up to11-13 volts. The computer is not getting voltage, and I suspect that the battery cables, possibly the neg cable is corroded inside the clamp and not allowing enough voltage to get to the starter or the computer. Take the neg and pos cable clamps off and using a piece of sandpaper or emery cloth clean the inside of the clamps, and the outside of the battery pole. re-assemble and try to charge the battery up. The jump start should work now, but be careful that you have the correct pole to pole as a reversal would destroy the diodes in your alternator.

Jan 22, 2011 | 1994 Buick Skylark

1 Answer

WHERE IS THE ALTERNATOR ON A 1994 BUICK SKYLARK?


This car came with a 2.3L 4 cylinder or 3.1L 6 cylinder, so here's both, hope this helps you.


255d461.gif268a081.gif

Aug 12, 2010 | 1994 Buick Skylark

1 Answer

1985 the volt light comes on when you turn off the ignition. It stays on and drains the battery


It's your alternator , faulty diodes and usually a replacement is more economical than trying to repair , ie off the shelf replacement and no down time ! Good luck

Apr 10, 2010 | 1985 Buick Skylark

1 Answer

1994 Buick Skylark overheating


This vehicle uses a 195 degree thermostat. Standard operating temperature is about 210. If the vehicle was running 160 before then the thermostat was probably stuck open before.

Jun 17, 2009 | 1994 Buick Skylark

1 Answer

Replace alternator 1994 Buick Skylark


what side is for losse the screw in the crank pulley in the buick 2.4l?

Feb 24, 2009 | 1997 Buick Skylark

1 Answer

Changed alternator, battery light still on, volts a little low


I had the same problem...check the wires on the plug leading into the alternator and also the grounds

Oct 05, 2008 | 1994 Buick Century

1 Answer

1993 buick skylark serpentine belt removal


there is going to be a tensioner pulley near the front of the motor on top that you have to apply pressure to or you can loosen the alternator and take it off that way,just remember how it came off so you can put it back on

Aug 13, 2008 | 1994 Buick Skylark

Not finding what you are looking for?
1994 Buick Skylark Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...