- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The replacement of outside rearview mirrors is straight-forward and can be done in an hour or so. If you need new power mirrors, first shop with local body parts suppliers in your area. The after-market mirrors are nearly identical and can be purchased for about $20-$30 per side. Remove the plastic triangular cover over the inside of the mirror by lifting up at base and then release clip at the top which is an upward motion off of a slot in the rear of the triangle. Then pull out the foam insulation carefully. The 3 nuts are 10mm and a long scket works best. For the one at the very front, you will have to use an open end wrench to loosen the nut. There is not much room for a socket. Be carefull to not drop the nuts down the inside of the door, because you don't want to remove the door panel and then the inner metal panel to get them out. If you lose them, buy new ones or replace with proper treaded ones in your garage. After the three nuts are off you need to disconect the wiring. Stop here and make sure you have enough slack in the wiring to be able to hold the female end securely, while you refit your new mirror. I took a piece of wire an dwrapped it around the female end to keep it within reach to re-attach the wiring after the nuts are tightened. Then just replace your foam insulation, and install the triangular cover and you're all set.
u may be able to just remove plactic on inside or door in mirror area to expose wiring and mounting bolts but if its apart of door panel u have to remove panel most cars and trucks allow u to sneak that triangular plastic piece out with panel on should be 1 screw ant clip holding it on hope this helps u!
On the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge. Then you'll need to manipulate the panel
and disconnect the door handle linkage from the door handle and
disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
no special tool its easy take mirror cover of inside that is then look for little caps take them off and then take screws out look aroung=d the trim pull out at bottom then pull on sides thenpull up and out the take or unhook switch panel take off trim take off vapor barrier then replace handle wallla then go back
First unscrew all the screw on the door then remove interior panels gently with screw driver and open the protective plastic film then remove all the wirings from the car and then remove the bolt from the car body and fit new door and make the wiring should be plug to car door as earlier...................