Question about 2005 Chrysler Town & Country

1 Answer

2002 air does not work been shop 3 weeks new every thing now they say high end pussure to high

Posted by on

  • mike loshbough
    mike loshbough May 11, 2010

    I believe your high speed fan is not working to cool down the condenser this will give you high pressure.Or a closed exspansionvalve



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert whose answer got voted for 20 times.

  • Expert
  • 109 Answers

Expansion vale most likely stuck or restricted

Posted on Jun 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have an 05 Ford explorer XLT 4WD I have a growling noise in the front end and every so often the advance track abs lights come on as well as the 4WD high light flashes Is this an abs sensor problem or...

No one can guess to give you an answer

The vehicle needs to be diagnosed

Look at scan tool data,lift check & road test

You should not have been using it for the
last two weeks knowing there are noises
& problems !

The tires may be an issue

Simply using the air gun that all shops use
to install wheels & everything else, may have ruined
the hub bearings,no shop follows the proper work

These shops create more problems than they find &
are capable of solving

Mar 08, 2014 | Cars & Trucks

1 Answer

2002 impala horn goes off by itself

Highly suspicious the problem is in your horn button.
And that might be on your steering wheel.
And that is where your Air Bag is. And that might mean you have air bag/horn button problems !!!!
Check with some good junk yards or body shops and see if you can find out how to change the horn button/air bag.
I just learned how 2 weeks ago, and it was really easy.
In my town, good used airbag/horn buttons go for $ 25.
Be blessed.

Jan 21, 2013 | 2002 Chevrolet Impala

1 Answer

My 2002 Chrysler , tire indicator comes up everyone to two weeks

Like he said you have a leak in the tire ,rim or valve go to a different shop that doesn't have twelve year olds working there

Nov 30, 2011 | 2002 Chrysler Town & Country

1 Answer

On a dodge caravan the pedal goes to the end without brake

Abs system cannot permit air to enter the hydraulic system, You need to check everything for leaks. Likely you have slight seepage somewhere, likely at or in a line going to the wheel you found you had air again. Leak does not have to be large and at this point likely is leaving only damp residue. If air was in the front, also check inside the caliper piston boot....If at rear, check for dampness under the wheel cylinder end boots.

Jan 13, 2010 | 2002 Dodge Caravan

1 Answer

Heater/air cond blower only works on high. any

It is the Blower Motor Resistor located behind the Glove Box on the dash. Remove the Glove box to access. It is mounted against the fire wall. This is a common problem. My 2002 did the same exact thing.
1. Disconnect the negative side of Battery.
2. Disconnected the Electrical Connection to the Resistor.
3. Remove the bolts/screws. I believe they have 8mm heads, there should be 2 of them.
4. Replace with new one.
5. Reconnect the negative side last.
6. Test System before putting the glove box back in!
7. Enjoy the CONTROLLED HEAT!!

Nov 24, 2009 | 2003 Chrysler Town & Country

1 Answer

Battery keeps dieing..jump start and runs for a few days and dies

Humm ...Didn't die before the accident? now dies? BMW has good mechanics,but could not find any problem???. I gota think that it is related to the rear ending,but how? I would look for loose connections, Battery Ground that might have been removed before welding.Battery terminals, Any primary connections that may not be making 100% contact . It's worth a try.Good Luck

Sep 09, 2009 | 2003 BMW 325

5 Answers

2002 Citroen C5 keeps dying on the road

Replace transmission fileter, remove and clean idle air control valve, clean fuel injectors if you have them, change fuel filter, plugs, wires and distributor should solve the problem.

Jun 28, 2009 | 2006 Peugeot 505

1 Answer

Flooding 2002 ford focus lx

PossibleTemp Sensor as it Determines for ECM to go full Rich in cold weather If That Doesnt Correct it. I Would Just Get a Block Heater then it wont Sence COLD temp and go Full RICH.

Jan 17, 2009 | 2001 Ford Focus

1 Answer

Catalytic converter needs replaced

No the Cat may have failed due to the timing belt failure (high exhaust tempertures), but not due to the work they did to replace it, I have 30 years of being a technician to back me up on this one.

Aug 18, 2008 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
2005 Chrysler Town & Country Logo

Related Topics:

40 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80668 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides