- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check to see if you are getting voltage to the blower motor if you are the motor is bad if not check the fan speed switch. 1 2 3 or low medium high if you get voltage going to the switch but not from replace the switch if you have voltage from switch check the blower motor resistor the although with the blower resistor you commonly have a high fan speed in the max setting and the lower speed settings don't work wich would make you think 1 2 3 are not working but 4 is. That is why it is best to check all parts to make sure the part you do replace needed to be replaced
If the fan will not run on ANY speed in your Grand Marquis, the problem is most likely NOT the control switch.
Check for power and ground at the blower motor connector. If power and ground is present, replace the blower motor. Otherwise, the problem is most likely a failed blower speed control module (VERY common). The blower motor speed controller is located in the A/C evaporator housing just below the heater hoses.
Note: It is also common for a bad blower motor to CAUSE the controller to go bad. You MAY have to replace BOTH.
Two possibilities I can think of. #1. The blower motor itself is dead, or #2. The blower motor resistor is fried. Blower motor resistor, however, is more known for taking out certain fan speeds, such as the lower fan speeds.
I had the same problem with my 2000 Mercury Grand Marquis. I ended up replacing the blower and the resistor which is on the passenger center side of the firewall tucked in where it is hard to get to. Everything worked fine for about two years. It just went out again here about a month ago. I am going to try to replace the resistor again, but I am wondering if it doesnt have something to do with the climate control switch. I do not want to replace the same part every year or two, so if anyone has a idea of what could possibaly be the bigger problem, please let me know.