Question about 2002 Hyundai Santa Fe

1 Answer

Where is the resistor block for a 2002 hyundi santa fe?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 40 Answers

It just under the dash next to the flux capacitor. Sorry, couldn't pass that up man.

Posted on Jun 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to find and replace blower motor resistor on 2002 hyundai santa fe 2wd


I don't know about a Santa Fe, but on most cars it is real near the blower motor.

Dec 12, 2015 | 2002 Hyundai Santa Fe

1 Answer

Need to know where the crank censor is on a 02 Hyundai santa fe


THE CRANK SENSOR IS LOCATED ON THE ENGINE BLOCK NEAR TRANSMISION BUT CALL YOUR DEALER THIS TRUCK HAVE A RECALL FOR THE SENSOR

Oct 05, 2014 | 2002 Hyundai Santa Fe

1 Answer

2002 Hyundie Santa Fe cuts out when I step on the gas t


run fault codes and check maf/masp/vap sensors.

Jan 28, 2014 | Hyundai Cars & Trucks

1 Answer

Lower ball joint 2002 hyundi santa fe


Typically these are replaced with a complete lower control arm. What happens is the ball joint is reseeding the lower control arm and rusts. When the old ones pressed out it distorts the opening in the lower control arm. When the new one is pressed in they never fit tight. Anew lower control arm is very easy to replace. 1. Jack up the vehicle on the sub frame or pinch weld. 2. Remove the pinch bolt that holds the ball joint to the knuckle. 3. Separate the ball joint from the knuckle. 4. Remove the two bolts that secure the horizontal bushing to the sub frame. 5. Remove the single bolt that secures the vertical bushing from the subframe. 6. Remove the lower control arm. If you have any questions I'll be happy to answer them.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Sep 25, 2011 | 2002 Hyundai Santa Fe

Not finding what you are looking for?
2002 Hyundai Santa Fe Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...