Question about 1992 Mitsubishi Galant

1 Answer

I had no prior problems, no tranny slipping, just stopped moving the car runs but doesn't move i have a 1992 mitsubishi galant 2.0

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 353 Answers

Check front axles, one or both may have popped out of transaxle

Posted on Jun 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 jeep wrangler will not go forward only reverse has standard transmission


does dont move mean it slips

can you move throttle to say 3000 rpm and car will not move.

this is gross slip. or FLare. RPM matters. here.

why?, because the engine must be good, to move forward.



hot and cold engine? no move forward.? or both?

standard means manual transmission.

so the clutch is bad.

my guess is you meant it has a A/T box.

mine has a 6sp, M/T box.

apples and oranges diffr.

this car had 4 transmission options day1 factory build day.

4.

2 auto

2 manual standard, stick.

ill guess at 32RH at (not AW-4 auto) 32RH is a 3 speed.

hydramatic.

levels good, per the operators guide, do not guess, use the steps in the guide, the A/T box is not checked like the engine, at all.

is the fluid, pink (ATF) or black and with metal flakes, dripping off end of dip stick. or stinks, smoky not sweet smell.

???????

is the shifter moving the shift side crank on tranny correctly?

this takes careful observation .





  1. level checks, and lever action.


  2. replace the filter now. was this step skipped for 22 years?


  3. get the full flush no , may be the AFT fuild types were mixed up?


  4. this means the stall test fails, (dont move)


  5. so in the FSM the next test is the pump pressure test port test. called LINE checks, this is next. if fail the tranny is bad.


  6. whats next depends on %5


the tranny pages below, pdf page 71 shows the 1st line test.

there are 5 line tests.

if you can do that, , then find a shop that can.

you will never get to the stall test because the tranny slips. test 6



see yJ 93, tranny

http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Sep 09, 2014 | 1992 Jeep Wrangler

1 Answer

How to solve a problem in mitsubishi 4g93 GDI, the car is auto,when moving forward gear is not changing and the revs is okay,and the car is moving but with only one gear always..Kindly help please.


If the transmission is not actually slipping, the most likely culprit is the "governor" in the transmission. Fairly easy repair for a transmission shop.

May 19, 2014 | 1997 Mitsubishi Galant

1 Answer

When i put car in reverse makes a winding noise and wont shift an any other gears


if engine rpm advances (fast to 3000), and the car dont move
the tranny is bad (what part , dont know)

so did you get to 3000 ENGINE rpm and car didnt move.?
that is bad trans. its slipping
1: check all fuses
2: check levels of ATF in tranny
3: do the 50,000 mile full flush and filter. change and pray?
4: do the FSM stall test, It fails, bad.
5: step 2 in FSM after above fails, measure (gage) the tranny pump pressure. if bad pressure (2 tests) tranny is bad.

all that is in FSM
or alldata.com login and read ON CAR tranny tests.

Jan 24, 2014 | 1992 Honda Accord

1 Answer

Engine run won't run my engine is v6a12


can you move it by hand?what noise do you hear when trying to start.
is the gear from the starter full in the motor.are all wires connected.

Jul 26, 2012 | 1992 Mitsubishi Galant

1 Answer

I have a 1996 Mitsubishi Galant S with a manual transmission and when i step on the gas pedal in first gear the car doesnt move. When I put the car in reverse, it doesnt move. Prior to this happening my...


For a manual transmission, this means your clutch has completely failed. The loud noise was likely not a belt, but the cluch release bearing. I'll bet this was a screeching noise that reduced or stopped when the clutch pedal was depressed.

You'll need a new replacement pressure plate, driven plate, release bearing and anything else that is found to be worn out when the the transmission is removed to do the job. A garage would need 4-6 hours labour to do this.

SD

Jun 25, 2011 | 1996 Mitsubishi Galant

1 Answer

Tranny problems will run for short time after startup then stop moving ,motor will still run but car wont move let it sit for some time and then it will move again


first of all, check condition of tranny fluid. if it is brown or smells burnt the clutch in tranny are slipping. if the fluid is ok and at normal on stick. then change the fluid and tranny filter. this may help. have a good one !! but if it still slips, tranny is in need of repair or replaced.

Nov 18, 2010 | 1992 Dodge Stealth

1 Answer

My 1999 Galant makes a slipping sound at 3 thousand rpm could the transmission be the cause and what can I try to save it the car still runs good.


Slipping usually means the stator in the torque converter is on its way out. Its disengaging before the particular gear has built up enough torque to let you shift and move calmly. Nothing you can do its time for a rebuild tranny or a new car. Best of luck to you.

Jun 14, 2010 | 1999 Mitsubishi Galant

1 Answer

HI I have a Mitsubishi galant 98 ...while I was driving I heard a rear wound and I stopped the car...but then I try to drive again but the car won't go forward not in reverse ...I noticed that the...


Don't shot the messenger but without tranny fluid your transmission may have cooked itself. I hope I am wrong but I expect you'll need to rebuild or replace the tranny.

Wish I could offer better news,
Tom

Apr 28, 2010 | 1998 Mitsubishi Galant

2 Answers

1992 Mitsubishi Eclipse transmission slips in overdrive


well the low cost way to go first would be to try and change the trans fluids. If the problems still remains the it may be an internal problem

Feb 25, 2009 | 1992 Mitsubishi Eclipse

Not finding what you are looking for?
1992 Mitsubishi Galant Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...