Question about 2004 Chrysler Sebring

Open Question

How to change rear rotor/brake pads-2004 sebring

Change rear brake pads/rotor-2004 sebring

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: 2004 Toyota Camry Brakes

Raise the vehicle up and remove the rims & tires

Remove the brake pads, and then remove the calipers from the caliper retention brackets, do NOT remove the brake hoses from the calipers.

Remove the caliper retaining brackets from the hub assemblies (2 large bolts on backside of the bracket)

Tap the brake rotors off of the hubs, hit them from the back side of the rotor.

No big mysteries here, this is a very easy job.

Posted on Oct 21, 2008

  • 1 Answer

SOURCE: how do you replace rear rotors and brake pads on 2006 Jetta

There is a special tool you need to do this. It is virtually impossible to do without this tool. I got mine from Harbor Freight for $20. the kit comes in an small orange case and has multiple heads and it pushes and turns at the same time. Do not use a C-clamp, it will damage the piston. This tool still does use some manual labor, but it is worth it when you save a few hundred dollars doing it yourself!

Posted on May 08, 2009

  • 1 Answer

SOURCE: rear brakes

I changed the rear pads this fall, have you removed the caliper retaining bolts and the Park Brake Cable? I remember the cable being a pain and using a large hammer and pry bar to loosen the caliper. You can pry on the edge of the pad and the hat section of the rotor. The rear rotors aren't expensive and should be done at the same time.

Posted on Dec 17, 2008

  • 142 Answers

SOURCE: PULSATION WHEN APPLY BRAKES

Even though you replaced the rotors, seems that you will still need to have them resurfaced. This assuming you are experiencing pulsation only when braking.
Hope this helps, Please remember to rate this answer.

Posted on Feb 12, 2009

emissionwiz
  • 75842 Answers

SOURCE: i need to know how to change the brakes and rotors on a 1996 chrysler sebring convertible jx series.

Go to link below for instructional video's on brake rotor replacement.

http://video.google.com/videosearch?q=how+to+replace+brake+rotors&www_google_domain=www.google.com&hl=en&emb=0&aq=0&oq=how+to+replace+brake+r#

Posted on May 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What tools do i need to change brake pads on 2005 yukon xl


Jack, wheel wrench, socket set, large screw driver, pair of pliers or grips. Lithium grease for the pins. Watch all of these videos. .spell{font-size:18px}.spell_orig{font-size:15px}#mss p{margin:0;padding-top:5px}




g-img{display:block}._WCg{display:block;border:0;position:relative} Search Results

    How To Install Replace Front Brake Pads 2000-06 Chevy ...

    9k=? 4:46 https://www.youtube.com/watch?v=nPohZtD8zlA May 27, 2014 - Uploaded by 1A Auto Parts http://www.1aauto.com/brake-pads/i/1abps00080 1A Auto shows you how to ... Front Brake Pads 2000-06 ...

    HOW TO INSTALL REPLACE GMC YUKON DENALI ...

    z? 14:10 https://www.youtube.com/watch?v=um7dt_yvZ1s Sep 20, 2012 - Uploaded by TheRykerDane Video on how to change the brake pads and rotors on a 2004 GMC Yukon Denali. Changing these parts ...

    How to REPLACE INSTALL BRAKES and ROTORS GMC ...

    2q==? 11:32 https://www.youtube.com/watch?v=UWqows3P4DE Feb 11, 2012 - Uploaded by TheRykerDane Video on how to change the brake pads and rotors on a 2004 GMC Yukon. Changing these parts ... Would ...

    GMC Denali Brake Pads Removal and Installation - YouTube

    z? 3:45 https://www.youtube.com/watch?v=uEKs8nphVxU Oct 24, 2012 - Uploaded by AnotherLookFilms Remove and Install rear brake pads on your 2006 GMC Denali XL. ... 9-21-13 2007 GMC Yukon rear brakes ...

    GMC Yukon Denali Front Disc Brake Pad Replacement ...

    2q==? 8:21 https://www.youtube.com/watch?v=w_gn_l5lYkw Jun 20, 2013 - Uploaded by AMS Automotive Watch the proper procedure for replacing front disc brake pads. Featured vehicle: 2007 GMC Yukon Denali ...





Jan 22, 2016 | Cars & Trucks

1 Answer

Replace front brake pads


1. Raise vehicle
2. Support on jack stand
3. Remove lug nuts
4. Remove wheel
5. Remove bolts holding caliper
6. Remove calipers
7. Remove brake pads
8. Push piston into caliper
9. Inspection rotor for damage if damaged replace
10. Install new pads
11a. Replace caliper on rotor
11 b. Replace bolts in caliper and tighten
12. Bleed brakes
13. Replace wheel
14. Replace lug nuts
15. Lower vehicle
16. Tighten lug nuts
17. Test drive vehicle

Oct 17, 2015 | 2004 Chrysler Sebring

1 Answer

How do i remove the rear brake rotors on a 2004 chrysler sebring convertible?


there are two bolts holding the caliper bracket on. then after that they tend to get stuck to the hub. i usually tap on the rotor with a hammer to get them loose

Jul 02, 2014 | 2004 Chrysler Sebring

1 Answer

Car jerks when step on brakes


If you mean pulsates, this is your rotors. either get your rotors turned or better yet, replace your rotors along with brake pads.

Apr 06, 2014 | 2004 Chrysler Sebring Convertible

2 Answers

Does the 2003 gmc yukon have rear rotors? and do the brakes need to be changed if the rotors need to be machined?


Yes, it has rear Disc Brakes, I would suggest to change the rear pads since they have to remove the rear Brake Calipers to remove the rotors and it wouldn't take much more time or labor to replace the pads at that point. That way when your rear rotors are re-installed and your new brake pads are installed your rear brakes should give you longer service life and better stopping power.

Jun 04, 2010 | 2003 GMC Yukon

1 Answer

Video for replacing front brakes pads and rotors on a 2004 ford e


Hello,
ccr20011001bb00.jpg Brake Bleeding
Purging air and moisture from your binders
CarCare - Maintenance - Brakes

ccr20030701as00.jpg ABS Speed Sensor Service
A clean sensor is a happy sensor
CarCare - Maintenance - Brakes

ccr20030701db00.jpg Drum Brakes - Rear Brake Drum Adjustment
It's stupid not to adjust your rear drum brakes
CarCare - Maintenance - Brakes

ccr20050201rr00.jpg Replacement Rotors
Friction, brake rotors, and you
CarCare - Maintenance - Brakes

ccr20050501pb00.jpg Power-Bleeding Brake Systems
Air today, gone tomorrow
CarCare - Maintenance - Brakes

ccr20050701bp00.jpg Replacing Brake Pads
How to replace worn pads
CarCare - Maintenance - Brakes

ccr20071101bs00.jpg Bleeding Power Steering
Getting rid of that air in there
CarCare - Maintenance - BrakesThanks

May 29, 2010 | 2004 Ford Escape

2 Answers

How to remove rear brake rotors on a 2004 Santa Fe


THE REAR BRAKE ROTOR IS A LOOSE ROTOR AND SHOULD COME OFF EASILY. IF NOT, IT IS POSSIBLE THAT THE ROTOR IS HELD BY RUST ONTO THE HUB OR THE BRAKE SHOES IS STILL EMBEDDED INTO THE ROTOR. REMOVE THE HANDBRAKE CABLE TO ENSURE THAT THE BRAKESHOES COLLAPSE AND TRY TO LOSEN IT AGAIN. IF SEASED ONTO THE HUB BY RUST, KNOCK THE ROTOR WITH A COPPER HAMMER TO BRAKE THE RUST WITH A RUST REMOVER.

Jul 15, 2009 | 2004 Hyundai Santa Fe

3 Answers

In 2004 Impala, do I have rotor or drums?


The best way to answer you question is to tell you to take the vehicle to your nearest dealer and inquire with the parts dept. I can tell you that on the ffront of your car you have rotors and the brake used on the front is called a pad. Also your vehicle does not have a separate parking brake. It is the same as the regular rear brake no matter which type of brakes you have on the back.

Jul 02, 2009 | 2004 Chevrolet Impala

2 Answers

2004 Toyota Camry Brakes


Raise the vehicle up and remove the rims & tires

Remove the brake pads, and then remove the calipers from the caliper retention brackets, do NOT remove the brake hoses from the calipers.

Remove the caliper retaining brackets from the hub assemblies (2 large bolts on backside of the bracket)

Tap the brake rotors off of the hubs, hit them from the back side of the rotor.

No big mysteries here, this is a very easy job.

Oct 21, 2008 | 2004 Toyota Camry

Not finding what you are looking for?
2004 Chrysler Sebring Logo

Related Topics:

1,276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...