The whole antenna needs to be replaced the old one was broken,at the base of the jeep.
Same as allcars
unbolt it, remove it.
is car in USA,
some cars have electric motor up/down antennas.
if USA ,the manual is free to read, posted over 300 times
search much.?
2000 Grand Cherokee, is name, WJ jeep
see AUDIO chapter
here ,its there, under WJ
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service
no need to guess,at all, its in the JEEP BIBLE
×
SOURCE: Head Bolt Torque for a 2000 Grand Cherokee Laredo 4.0L
the torque is a 4 step process
1 torque all bolts to 22 ft/lbs
2 torque all bolts to 45 ft/lbs
3 recheck all bolts to 45 ft/lbs
4 torque bolts 1 thru 10 to 110 ft/lbs
bolt 11 to 100 ft/lbs
bolts 12 thru 14 to 110 ft/lbs
bolt #1 is the fourth bolt from the front on the passenger side....#2 is the fourth bolt on the drivers side then you continue in a clockwise order
SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee
One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.
SOURCE: How to replace cv boots front end of 1999 jeep
dont replace the boots the cv is junk relace the shafts the shafts rebuilt are 59 or 69 $
Testimonial: "Thanks very much.With the economy we can only afford what is neccesary."
SOURCE: replacing the Antenna on a 2000 Jeep Cherokee
this is how we did it for my Dads jeep his was a 98 so it should apply. let me know if it doesnt and i'll go break it down on my friends jeep 2000
Unscrew the antenna and the base flat base nut. Unfasten the mud guard in the wheel well enough to pull it aside and reach up to the antennae. Remove the kick panel to find where the cable enters the jeep.
SOURCE: how to replace the Battery Temperature Sensor
it is located under the battery in the battery tray.
263 views
Usually answered in minutes!
×