I reprogrammed a key to my car i can unlock and lock the car but i cant get the car to start i think its my immobilizer but not sure can anyone help plese
SOURCE: Nissan Almera Tino Right hand side
YEs but if you are going to do some secrifice on your luck of car model from front,
otherwise its impossible,
you can get this from older car dealer or service center,
TNX
SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working
Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.
SOURCE: Problem with 2002 Nissan Almera Key Fob
check the battery in the key control it may be faulty
SOURCE: My Ignition key sensor is missing, the car wont start
Nissan dealer will charge in the region of £100.00 for a new key etc.
I got one from a local keysmith for £55.00.
SOURCE: how to find the heater resistor for a nissan
the majority of heater resistors are on the heater box under the passenger ide of the dash, on some very few models it is part of the actual ac control panel
Remote Control Fob Procedures:
The Central Door locking is controlled by the Multi-Remote Control system which controls
the door locking, door super locking and emergency hazard reminders.
When the doors are locked and unlocked the unit flashes the hazard lights once for lock and twice for unlock.
A maximum of four remote controls are allowed to be programmed:
ALMERA
ALMERA TINO
PRIMERA
MAXIMA
MICRA
SERENA
VANETTE CARGO
TERANO II
Ensure all the doors have been unlocked, either by using a good transponder key or remote
control plip key.
Procedure:
1. Turn the ignition switch from Position 0 to ON 6 times within 10 seconds.
2. Next, turn ignition switch to OFF position. Leave key in ignition switch.
3. Wait 2 seconds then the system will enter programming mode and will flash the warning
lights twice.
4. Press and HOLD the unlock button on the Plip.
5. While pressing the unlock button, press the lock button 3 times.
6. Release the unlock button.
7. The warning lights will flash once to indicate successful programming.
8. Repeat procedure 4 to 7 for up to 4 plip key's.
9. When completed turn ignition ON, and the warning lights will flash 2 times.
10. Remove key, and check all plip key's for operation.
NOTE : The programming mode will stop when either the ignition is switch ON, 4 plip keys
have been programmed or no input signal either from the switch or plip keys has been received
for 120 seconds.
http://www.autokeysquad.com/nissan-fob-programming
i hope this can help you.. :)
85 views
Usually answered in minutes!
×