Question about 2002 Hyundai Tucson

1 Answer

Engine hunting when start on neutral or park

I replace 6pcs sparkplugs.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 167 Answers

Could be the idle air control valve These Carbon up.Located on the inlet manifold around the throttle body in most cases but not all.

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can't get mark 8 1996 lincoln in to park


Your neutral safety switch is bad.The neutral safety switch is a safety device that only allows you to start your engine when the automatic transmission is in either Park or Neutral. ... This switch prevents you from starting the engine when the transmission is in any gear other than Park or Neutral.

Jul 11, 2017 | Lincoln Mark VIII Cars & Trucks

1 Answer

F250 wont go into Park, and have to start it in Neutral


when you park the truck dont move mean is on park but the range sensor is not working to make the by pass to make the truck to start posible you need to replace the range sensor or neutral safety switch

Oct 19, 2014 | Ford F-250 Cars & Trucks

1 Answer

Engine stalls while in drive and reverse runs rough in park or neutral


Begin with the basics......Start with a scan/check parameters

Jul 01, 2014 | 2002 Ford Excursion

2 Answers

Symptoms for a faulty neutral safety switch


No start (engine doesn't crank with starter motor) in neutral and park position, one or both

Oct 16, 2012 | Cars & Trucks

1 Answer

How do you replace an ignition switch on a 2002 chevy venture van? I have a 2002 chevy venture van and have had a problem with the starter staying engaged. I replaced the started and it fixed it...


So what it only does it in park or neutral ! The vehicle starting circuit is only suppose to let it start in park or neutal . Park neutral safety switch won't allow B+ voltage to S terminal on the starter solenoid unless the vehicle is in park or neutral . It's probably the starter relay contacts stuck closed . You really should learn how it works before guessing as to the problem . Plus learn automotive electrical testing ! The ignition switch when turned to the start position send's a voltage signal to the PCM - engine computer .The PCM will energize the starter relay to crank the engine . PCM / ABS 10amp fuse in the I/P fuse box supply's B+ voltage to the park / neutral safety switch . When in park or neutral the B+ voltage goes through the control side of the relay to the PCM which will supply a ground to energize the starter relay .

Jun 17, 2017 | 2002 Chevrolet Venture Passanger

1 Answer

How do you chance the back 3 spark plugs on 2004 grand am


first place wheel chocks around tires to keeps car from rolling .place parking brake on then take the two top front engine mounts loose and then place car in neutral.remove alternator, then carefully roll engine toward front of car. you can place a small wood block between engine and firewall to help hold engine forward. please be careful choosing where to place the wood block dont put it on anything breakable. then remove sparkplug boots one at a time replace plugs then reverse steps .
hope this was helpful

Oct 26, 2010 | 2004 Pontiac Grand Am

1 Answer

Wont start in park or neutral move shifter around in any gear then it will start sometimes


I'd look at replacing Neutral/park position switch.(or safety neutral switch.)
Where on transmission will depend on engine and transmission in vehicle. Autoparts guy should be able to give you an idea.

Dec 19, 2009 | 1995 Pontiac Grand Am

1 Answer

I replaced transmission and now car dont start


Test the neutral switch.

===

Foot on brake

MOVE SHIFTER BACK FROM PARK AND NEUTRAL 10-20 times. This will re-new the metal contacts.

Shift to netural "N"

Start engine

Put lever back to Park "P" to warm up the truck.

====

If it start from neutral and not park then you will need a neutral safety switch.


Please rate my answer if it's helpful to you.

Cheers,

MUSTGO

Dec 14, 2009 | 1998 Cadillac Catera

1 Answer

Engine starts only in neutral. when placd in


I'd be replacing neutral safety switch at transmission.

May 18, 2009 | 1997 Mercury Cougar XR7

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...