How much would it cost to replace a computer in a 2006 saab?

SOURCE: key replacement cost 2008 Saab 7x aero

Is it just a "physical" fit problem?
Because if it is merely this and not your electronics you could always buy another key on ebay like this
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=310130782609

.......then all you would have to do is pop open the casing like you were going to remove the battery, instead pulling the little circuit board also and replacing it with your own one in your damaged fob!!

mx5turbo92

• 545 Answers
• Posted on Jun 04, 2009

SOURCE: remove/replace shock absorber assembly 900s 1995 saab

1. Slightly loosen hub center nut when all four wheels are on ground.
2. Raise and support vehicle, then remove five wheel bolts and wheel.
3. Remove hub center nut, then the wheel sensor,
4. Press back brake piston using slip-joint pliers,
   
5. Remove caliper from steering swivel member, then suspend in wheel housing with cable tie.
6. Remove brake disc and back plate, then slightly loosen tie rod end nut.
7. Press out tie rod end nut using puller tool or equivalent.
8. Remove nut and tie rod end bolt, then the anti-roll bar to swinging arm nut.
9. Remove outer ball joint nut.
10. Press ball joint out of steering swivel member using puller tool or equivalent, installed on spring link.
11. Remove nut and discard. This self-locking nut must not be reused.
12. Remove three upper mounting nuts for MacPherson strut, then the strut.
13. Clamp MacPherson strut in vice.
14. Compress spring using spring compressor or equivalents.
15. Hold piston rod and remove nut using MacPherson strut socket tool 89 96 662, or equivalent. This is a self-locking nut and must not be reused.
16. Remove mounting and top spring seat, then the coil spring, gaiter and compression stop.
17. Unscrew damper using wrench tool No. 89 96 670, or equivalent, then remove damper from strut.
18. Reverse procedure to install, noting the following:

1. Screw damper in place using wrench tool No. 89 96 670, or equivalent.
2. Lower end of coil spring should abut against stop in bottom of spring cup.
3. Position MacPherson strut on vehicle and install three retaining nuts on top mounting. Tighten nuts alternately, according to specifications.
4. Always use new hub center nut with self-locking threads.

SOURCE: Saab 9-5 air conditioner is out

If problems with the compressor 160 if the 190 engine is 4 cylinders 6 cylinders if these prices do not include gas or recharge parties. If the evaporator 230 or approximately 250 more parts

SOURCE: MY 2000 SAAB 95 NEEDS THE TURBO REPLACED IN ORDER

Elite foreign auto used saabs parts

gord storey

• 477 Answers
• Posted on Nov 09, 2009

SOURCE: how do I replace my 2004 Saab 9 3 linear's water pump.

Re : the computer , they better cover it under warranty or they ****.
Re : the water pump , you have a leak and they say it is the water pump , I have no reason to doubt that they have honestly checked out the problem and determined that a new water pump is the only solution but , damn $ 1000 is pretty steep. I would look around for another mechanic for a second opinion and a quote. Avoid dealerships. Not sure what engine you have but i just looked in my saab with a 2.3 and hope I never have to do mine. I am pretty good with a wrench but I know there would be lots of swearing involved.