Question about 2002 Chrysler Town & Country

1 Answer

A/c and heating fan problem

The fan only works high all other speeds don't work for both front and back

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 65 Answers

Easy there is a set of of resistors that make speed selector work when they burn out they fuse together and lock in the full speed ( high) position this is for safety. you got to have defrost to see right.
anyway they are located near the fan usually under the passenger side dash jsut replace the resistors. you'l be fine

Posted on Jun 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 chrysler town country radiator fan don workin high speed


If you have a viscous fan hub attached to the fan then it will not be working at high speed as there will be enough air flowing through the radiator to keep things cool. They only really work at high engine loads and slow speeds (hill climbing ) and at stop lights where the air flow is nill

Jan 22, 2014 | 2009 Chrysler Town &

1 Answer

Rear blower: only works on high when set on cold, won't work at all when set to heat


I would start with the rear blower motor resistor, the resistor is what controls the speed of the fan, the resistor is located in the rear heater box near the blower, you will need to remove the right rear side panel to access the heater box. start with that

Dec 07, 2012 | 2004 Honda Odyssey

1 Answer

The only speed on my heat/air fan the will work is high. All other speed quite at the same time. Would this be the fan motor or could it be a fuse?


It is most likely the fan switch, all the low speed work through a resistance, the full speed does not, there is only one fuse for the fan so if it works on high its ok and you say the fan works on high so the fan itself is ok

Apr 17, 2010 | 2005 Ford Taurus

2 Answers

2004 chyrsler pacifica front fan stops on high


Replace the resistor in the front fan system.

Nov 12, 2017 | 2004 Chrysler Pacifica

1 Answer

Fan on High Only


The fan motors use a set of resistors to control fan speed. The lower speeds generate more heat in the resistors and these tend to burn out. While it is possible the switch could be the issue, I would start with the resistors. It is usually a module located somewhere near the blower motor.

Note: One of the reasons these go out, is that with time the bearings on the blower motor go bad and the motor takes more power to run. If the replaced resistors fixes the problem, but then fail too soon, look at replacing the blower motor as well.

Aug 29, 2009 | 2005 Ford Excursion

2 Answers

Blower only works on high speed


i agree with solution 1. i see it all the time

Jul 29, 2009 | 1999 Plymouth Grand Voyager

3 Answers

Heat/AC Blower fan speed only works on High


Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.

Jan 14, 2009 | 2005 Jeep Grand Cherokee

3 Answers

Heater fan regulation


2002 Grand Caravan. The rear heater also has a resistor for the fan speed control.(3 speed) It is located under the rear passenger side plastic cover. You can take off the rear tail gate lower plastic piece and this will let you pull out the side panel. You can reach in and take out the two screws that hold in the resistor and unhook the wiring adapter. You do not have to take off the whole side panel as you can reach in from the back. The resistor unit can be bought at you local dodge dealer.

Nov 30, 2008 | 2002 Dodge Grand Caravan

Not finding what you are looking for?
2002 Chrysler Town & Country Logo

214 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...