Question about 2005 Nissan Murano

1 Answer

2005 murano with shaking and loud cabin noise

My 2005 murano shakes horribly with loud cabin noise. it doesn't occur all of the time, sometimes it starts halfway through my drive, and stops halfway through. it's not consistent in when it happens so i don't know exactly how to describe. tires or engine?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 721 Answers

Well with this limited info,not much I can say. Try changing from left to right in an aggressive manner on a clear street to see if the noise comes back. If so,it's probably a wheel bearing. If that's not it it could be a serious transmission problem , like the torque converter lock up switch.

Posted on Jun 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

06 Murano steering shakes when accelerating around 60 mph. Just balanced tires, still shakes. Doesn't shake while coasting same speed


Do you feel the shaking in the steering wheel as well? If so, it may be a worn steering linkage. If not, have your CV joints and U-Joints checked and, if you have a 4WD, have the transfer case output shaft bearing checked.

May 21, 2015 | 2006 Nissan Murano

1 Answer

Nissan murano shakes at high speed


Most likely a bad tire ( broke belt etc) or alignment problem.

I would try the tire shop first. Sometimes you can see a bulge on a bad tire.

May 17, 2014 | Nissan Murano Cars & Trucks

1 Answer

2005 jeep cherokee front end pulsating


THAT IS A BAD SIGN
AND IS A HANDS ON check
any time brakes do that, its a huge SIGN OF DANGER To you and others.
get off the internet and find hands on, help.

Mar 07, 2014 | Jeep Cars & Trucks

1 Answer

Bower fan in 06 murano how do i replace it


99% of vehicles they are right above where your passengers feet are. typically 3 screws hold em in there and a connector. your owners manual may show how to change the cabin filter. do that while youre in there too.

Jul 21, 2017 | 2006 Nissan Murano

1 Answer

I have a 2005 chevy cobalt, and it has been driving fine until a couple of months ago. One day it just started shaking and my engine light started to flash on and off. I got it checked out and they said it...


It sounds like the catalytic converter might have come loose causing a loud exhaust leak. Did they repair the problem that caused the converter to plug up like a defective oxygen sensor or coil pack?

Aug 19, 2013 | 2005 Chevrolet Cobalt

2 Answers

I have a 2005 Toyota Solara SLE. I having problems with the front end. The car shakes/shimmies upon accelaration at approx. 40 mph. It smoothes out if you take your foot aff the accelarator but shakes...


Check the condition of your tires and suspension. this problem is usually caused by bad component or alignment. Special attention is given to camber and caster.
alignment%2bchart3.jpg

Jan 21, 2013 | 2005 Toyota Camry Solara

1 Answer

My 2005 saturn vue makes a loud noise,shakes,wont go very fast and shuts off


The only thing that can make a loud noise shakes and go very fast, Is a open TAC (Throttle actuator motor) being stuck open. This applies to a 4 cylinder and 6 cylinder.A disconnected MAF (mass air flow) if this duct came out same situation, Just inspect the duct make sure its on.

Mar 09, 2012 | 2005 Saturn VUE

1 Answer

When accelerating (aprox 30-60km only) rumbling happens. If you let up on the gas it stops, but as soon as you re-press the gas it rumbles again. Shakes entire vehicle. Help!


If the noise also occur when the car is at full stop while reving it high then have the engine observed while the hood is up. See if there is excess shaking it may be a bad engine support. If it only occurs when the car is running it may be the drive shaft or the transmission. You may need to raise the car and inspect the drive shaft down to the transmission. At times it could also be just the wheels depending on the noise and the shaking. Check first the wheel, have the front swapped with the back and see if there is a significant change. Your wheel may just need balancing. While at it inspect the thread for uneven wear. You may need to do some alignment of the wheels.

Apr 03, 2011 | 2005 Ford Escape

1 Answer

Lexus sc400 electrical problem


the computer is bad and also these cars are known for the insturment clusters to go bad along with the computer. get them both fixed and it will solve your problem.

Aug 10, 2009 | 1992 Lexus Sc 400

1 Answer

1993 Lexus SC400- alternator has been replaced twice but dash lights and headlights continue to flicker especially when breaking. When driving car the first 15 min or so it shakes and makes loud grinding...


First have battery checked at a Interstate battery place or equivelant. All issues point to low voltage. A shorted battery will cause the alternator not to work.

May 02, 2017 | 1995 Lexus Sc 400

Not finding what you are looking for?
2005 Nissan Murano Logo

561 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...