Question about 2000 Toyota Camry

1 Answer

Automatic window Hi, The automatic window on the driver door of my 2000 camry ce does not wind up immediately after winding it down. I have to wait about 3 to 4 minutes before it will wind up.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,077 Answers

Most likely the motor for the power window is worn out.
It's not that uncommon to replace these motors over time.
The motor is most likely over heating doing the job going one direction. Then, have to cool down to go the other direction. Hot and cold temperatures outside will play a factor on a worn-out window motor as well.

Posted on Jun 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I correct wind noise on drivers side door / window 1999 Camry?


There may be a torn, missing, or loose door gasket. If you inspect the seal and find torn or missing segments, repair or replace. If the seal is intact, the the most likely cause is a gap in the door seal near the top rear of the door. This happens over time because the door frame can actually get bent slightly outward. It is so little as to not be visible, but you can hear the wind noise. The way to get the noise to stop is to open the door and roll the window all the way down. Then, holding the door firmly, grasp the upper rear corner and pull it inward (toward to the car). A couple of sharp tugs will usually do the trick. I know it sounds silly, but it works. BE SURE TO HAVE THE WINDOW DOWN OR YOU COULD SHATTER THE GLASS!
The door frame is quite thin compared to other car body parts and will bow/bend if you pull on it. Start out carefully and if you don't get the results you want, try again with more force.

Nov 21, 2014 | 1999 Toyota Camry

1 Answer

My 2002 Toyota camry drivers side window is off track when it's rolled up. Water leaks in and when your driving there is wind noise


You may have to review notes on how to remove the drivers side panel and replace one of the broken screws that hold the glass in place on the bottom rail. I believe the cause my be that and if not it may be a sticky guide rail. Try rubbing some furniture polish on the edge of the glass that sticks (usually to opposite side of the one that does not match the door). This may help to get the glass sliding smoothly again.

Mar 19, 2013 | 2002 Toyota Camry

1 Answer

Toyota prado side windows code


if the parado has automatic windows and they are not working from the driver's seat then wind down windows from each door and then pull them back up and keep the button pulled up for a few secs, this will reset the controls and the windows would start working from Drivers door, this has to be repeated number of time for each door

Jun 15, 2010 | 2006 Toyota Land Cruiser

1 Answer

Volkswagen passad 1999 automatically winds down


check the loose connection in the driver's door at the window motor/module

Mar 07, 2010 | 2001 Volkswagen Passat

1 Answer

How to remove a wind up window handle


handle is retained by a 'clip' that fits into a groove in the widow regulator stem.with handle facing down,[6 o'clock] use a cloth under handle at the round part,give it a 'shoe shine' motion while pulling up on cloth to dislodge spring clip enough to grasp and remove it.you can also press back door panel & dislodge clip with a small flat blade screwdriver.

Oct 18, 2009 | 2000 Toyota Camry

1 Answer

1990 toy. camry. intermitent problem with electric window controls (drivers) and (drivers) automatic seat belt. now completely stopped working. ??


Did you check the fuses? open the drivers door should be down there above the pedals, if more major problem open the hood and check the fuse box on the driver side of the car, more fuses are stored there

Jul 25, 2009 | 1990 Toyota Camry

1 Answer

Very loud wind noise around R/F passenger door


wind window down hold top of door frame put your knee on door and pull frame towards you this will give a tighter seal

Nov 18, 2008 | 2000 Chevrolet Silverado

1 Answer

Voyager 1994 front windows


you need to replace the drivers switch pack assembly, sometimes this happens from rain water and other times the contacts just wear out, its about $25 on ebay and they are a common failure item... good luck and please rate -Jeff

Jul 29, 2008 | 1994 Plymouth Voyager

Not finding what you are looking for?
2000 Toyota Camry Logo

Related Topics:

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...