Question about 1990 Chevrolet Lumina APV

2 Answers

Car want start after motor gets hot and car has been driven

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is a sensor wire that needs snipped, had it on two cars

Posted on Jun 29, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

Check igniton control module they sometimes like to melt and they work in the cold and not when hot

Posted on Jun 29, 2009


2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 5 Answers


did you diagnose your car with OBD 1 tool. it may be your coolant sensor. check wire with electrician. check your thermostat also and other sensors if have.

Posted on Aug 24, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

97 deville northstar where are fuses and relays located

under steering wheel to left ,if it's the motor running hot don't wait get on it northstar motors are big problems when it comes to keeping motor cool head gaskets ,and ,the water pump is a piece no well made,it's driven off the cam on the drivers side of engine.

Mar 17, 2017 | Cadillac DeVille Cars & Trucks

1 Answer

When driven for a while and machine is hot, car will not start for 30 minutes. Starter just clicks. Battery good and all functions working. Cooled down it starts again. What is the problem

Check positive cable and terminals on the starter motor are clean and tight. Your starter motor and cables may need heat shielding as resistance raises with heat.
You could also try a heaver cable to the starter motor. Also check the earthing wires between engine and chassis, and extra earth wires will help.

Jun 05, 2015 | Cars & Trucks

1 Answer

2000 Ford Ranger hard to start:

Unfortunately there are many things that could be causing this. I would check the engine coolant temp. sensor ..and see what its reading with the engine hot. Your going to need a scan tool to get that reading...or just change the sensor...good luck

Nov 26, 2012 | 2000 Ford Ranger SuperCab

1 Answer

Our 2000 Ford Expedition only puts out heat after being driven a mile or two even if it has been idling for a long period

when idiling in the winter it doesnt get hot enough until you raise rpms, that gets the motor hot enough to open thermostat so water starts circulating throughout the whole system.

Aug 24, 2012 | 2000 Ford Expedition

1 Answer

When the car is driven and motor gets hot the car shuts down but when it cools down it starts and runs fine again until it gets hot

IT is most likely the thermastat but i would not suggest driving it until it fixed as that could cause the head to crack witch costs around $213 - $250

Jul 27, 2012 | 1993 Dodge Dynasty

1 Answer

I have a 97 nissan quest. One day my jug started bubbling inside of the resivior jug. So i thought that I could fix it by replacing the thermostat. Still ran hot after driven. So i then change my...

One thing you could do is start the car with the hood up watch the temp gauge and when it starts getting hot watch to see if the fan comes on if not it could be the fan motor or a fan switch . Hope this helps

May 31, 2011 | 1996 Nissan Quest

1 Answer


did you diagnose your car with OBD 1 tool. it may be your coolant sensor. check wire with electrician. check your thermostat also and other sensors if have.

Aug 14, 2009 | 1992 Toyota Corolla

1 Answer

1998 Ford taurus hot restart problem car doesn't want to start after being driven for long period of time. Must sit about 1 - 1 1/2 hours first. Then will start and run perfectly.

bad engine ground . check fuel system.too lean .engine running too hot.bad ignition module will cause starting problems when it gets hot.

Apr 28, 2009 | 1998 Ford Taurus

Not finding what you are looking for?
1990 Chevrolet Lumina APV Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides