Question about 1998 Chevrolet Blazer

1 Answer

Hood will not open

When I pull the latch release it makes a noise like it is releasing but it doese not pop up to the safty catch. The cable doses not appear to be broken.

Posted by on

  • djstyons Jun 27, 2009

    if I can't get it open I can't grease it.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

You should grease the latch with lythium grease after you get it open. If that doesnt work then replace latch. As long as it hasnt been wrecked or anything.

Posted on Jun 27, 2009

  • Nathan Thomas Jun 28, 2009

    You need to get someone to hit the hood with their fist while you work the hood release latch from the inside of the vehicle.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Hood release with broken cable 2002 odyssey


look under the dash see if cable is broken close to that end
grip inner cable with pliers and pull hard

if broken at the engine bay
work from under the car with a long tool to release the bonnet catch

if not sure how its done drive to a panel repair shop for a solution

26237636-f4vzkd3ydwillbxdzd1jhjup-2-0.jpg

Jul 14, 2016 | Cars & Trucks

1 Answer

2005 quattro , battery is dead and hood wont release.Is it an elecrtonic release?


Heidi, No electric release. The latch is probably stuck. While you pull the interior hood release have an assistant push down and pull up repeatably/vigorously until hood releases from stuck position. Lube latch and cable before closing hood. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Open Hood How To 2001 2005 Audi Allroad Quattro 2002 Audi Allroad Quattro...
2007 Audi A4 2 0t hood latch fix when you can pop the hood
Hood Latch Release Cable Broken How to open hood
Help Hood release cable disconnected somewhere any ideas how to open hood...

Apr 15, 2016 | 2005 Audi Allroad Quattro

1 Answer

Safety catch on hood wont release and hood wont re latch!


I would check to see if the hood release moves when the inside lever is pulled then pushed, if not the cable and latch mechanism may need lubrication or be broken.

Jan 05, 2016 | 1995 Ford F250

1 Answer

Hood release cable out from hood latch


from under the car you will need to get up to where the actual catch mechanism is located, from there you should be able to manually release the hood, it may take some effort , but there will be access,although limited... if there is part of the cable accessible grab it with vice grips and pull, hood should release. if not you'll have to find the part on the catch itself that the cable connects too and pull it to release.

Feb 13, 2012 | 2007 BMW 760Li Sedan

1 Answer

My 93 caravan the hood latch won't catch to keep the hood closed


Your hood latch probably isn't returning to the right position for it to catch. This is commonly caused by one of two problems: (1) too much hardened grease and crud on the latch itself is keeping it from operating freely; or (2) the hood release cable has gotten rusty or kinked over time and is no longer releasing completely.
I would suggest testing the hood release cable before doing anything else. It's an easy test and it only takes a minute. Enlist the help of a second person to pull the hood release lever while you look at the hood latch. When your helper pull on the release, you should see the cable pull part of the hood latch. When they let go, that part should swing back to its prior position. Using a long-shafted screwdriver, see whether you can "help" that moving part move any further on its return path. If you can push the latch any significant amount, it's not returning all the way to its proper position, and your hood release cable is probably binding.
In the short term, if you manually push the hood latch back into position, you should be able to close your hood again. However, you'll have to do this each time you open the hood. In addition, you run the risk that, not too far in the future, your hood release cable will actually completely bind or snap, and then you'll have a much harder time opening your hood to replace the cable (or do anything else, like add oil or washer fluid).

May 09, 2011 | 1993 Dodge Caravan

2 Answers

Hood release inside my 2000 ford focus popped to release but I can not open the hood of the car? what should I do?


Might just be stuck. Have someone pull the release as you FIRMLY pound on the front of the hood in the middle with your fist (NOT A HAMMER ! ! ! !).

If that works and it opens, get some WD40 and spray the latch and cable, lever, etc... and then work the release lever before closing it again. If the cable has broken....... it is very difficult to release without some automotive knowledge. I'm betting it is just stuck...


Good Luck.

Feb 06, 2011 | 2000 Ford Focus

2 Answers

How do I open the hood of a Mitsubishi L300 ?


  1. Locate the interior hood-release lever under the dashboard on the driver's side of the interior of the car.

  2. 2

    Lift up and toward you on the hood release lever. The lever is connected to a cable that releases the hood. The hood will pop up about 1/2 inch when you pull the lever.

  3. 3

    Move to the front of the car and locate the exterior hood-release lever under the front of the hood. It is located near the middle of the vehicle, just beyond where the front edge of the hood meets the body. Lift up on the inner lever.

  4. 4

    Lift up on the edge of the hood while holding the inner lever in place. When the hood is up, find the hood prop and raise it, setting its tip in the hood-prop mount on the hood, to hold the hood up while you work in the engine bay.



Read more: How to Open the Hood on a Mitsubishi Endeavor ' eHow.com http://www.ehow.com/how_6301122_open-hood-mitsubishi-endeavor.html#ixzz16Ou5FhQF

Nov 26, 2010 | Mitsubishi Lancer Cars & Trucks

2 Answers

How do i open the hood.


there should be a lever that is on the bottom edge of dash that is under the steering wheel along the trim. if the handle is broken you can use pliers to grab the cable and pull it to get the hood to realse. if you found all that and i seems to work ok then when pulling the release lever have a friend hit or shake the hood to get it to pop up a little so that you can open it all the way.

Nov 20, 2010 | 1997 Ford Explorer AWD

3 Answers

The hood will not pop open


There is no easy way to get the hood open to repair the problem, here are the common ways we technicians use to get the hood open when the release or latch is broken or stuck, 1st try pulling the outside sheath of the cable that pulls the hood open, it that fails try to reach it from underneath, without a lift rack that is very hard, the 3rd is through the grille opening, after 30 years and dozens of problems like yours this is the way I approach the job of getting the hood open.

Nov 18, 2008 | 1996 Lexus ES 300

2 Answers

Stuck hood on 2000 ford 250, latch release won't work


Ok, open the door, stand next to the door, pull the hood release while slapping your hand on the hood or have someone else lift the front edge while you pull on the latch..... should get in...

Oct 07, 2008 | 2006 Ford F-250 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...