Question about 2000 Jeep Grand Cherokee

1 Answer

2000 jeep cherokee - fan switch doesen't work - when I took module out the shaft clicks in the 4 positions but also continues to turn all the way around - is my problem the switch or is this normal for the switch?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Jeep Master
  • 1,564 Answers

Two words.....New Switch!!!!!!!!!!!

Posted on Jun 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Jeep cherokee 2000 heater fan does't run


If it doesn't run on any speed then check fuses and relay's under the hood in the power distribution box,if all are good then use a test light or volt meter on fan motor wires with fan switch set on high,if you have power there then replace fan motor,if the fan works on some speeds and not others than check the fan speed control module,it is located in the air duct on pass side below glove box.

May 03, 2010 | 2000 Jeep Cherokee

1 Answer

Hi i have a 2000 jeep grand cherokee the problem is the elec fan dose not turn on where is the sensor the turn on the fan. the fuels are ok.


This is controlled by a relay module .The location is under the passenger head assembly.Dumb location i know but that is were it is at.There is also problems with the fan assembly it self .Test for power on the red wire at the fan with the ac on this will make the computer tell the relay to start the fan. The relay module is not easy to get at :( i hope this helps .

Aug 11, 2009 | 2000 Jeep Grand Cherokee

1 Answer

2000 jeep cherokee sport - a/c heat control fan stopped working - the blower resistor looked burned so I replaced it - no change - next I relaced the control module - no change - the two related fuses are...


replace fan motor it caused the resister to go out check fan speed switch on back plug in burned? u also should have a fan relay that could be bad

Jul 03, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Throttle Position Sensor??


Sensor is attached with two torx screws on the throttle body. it is easily removed and is non adjustable. Be sure you engage the throttle plate shaft properly before tightening it up if unsure what it looks like, buy the new one first..

Jun 13, 2009 | 2000 Jeep Cherokee

1 Answer

I need to replace the water pump on a 97 jeep


there are 4 nuts on the back of the fan and a big nut on the fan shaft turn the one on the shaft toward the right

Apr 11, 2009 | 1997 Jeep Grand Cherokee

2 Answers

2000 jeep cherokee interior lights wont turn off


I would check the door adjar switches. IF all the door adjar switches check okay, then check the head light switch .

Assuming the head light switch and door adjar switches are okay , Then there is a wiring problem. This is the worst case scenario .

Mar 15, 2009 | 2000 Jeep Cherokee

1 Answer

Fan not turning off


You say that the air con is not cold, i think the problem would be the aircon will need regasing, if the gas has escaped from the system, the temperature in the aircon system will always be warm so the fan will continue working attempting to cool it down. It will need checking for leaks, most companies that recharge the system check the whole system for leaks first before refilling the system. If its the engine cooling fan it could be the thermo switch that is faulty,the way to check that is when the engine is cold disconnect the wires from the switch and put an ohms meter across the swith it sould not give any reading, it will only show a reading when the engine reaches operating temparature. hope that helps. regards Richard

Nov 01, 2008 | 2000 Jeep Grand Cherokee

3 Answers

1994 Jeep Cherokee will not start or even crank


I had the same problem with my 94 jeep and i ended up finding out what was causing the problem was the starter relay in the fuse box under hood, i believe its the second or third relay. Try turning the key to the start position and leave it there and poop open ur hood and manuelly start the relay

Oct 14, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...