Question about 2000 Chevrolet S-10

1 Answer

I have a chevy 2000 s10 pickup that sometimes will not go when I step on the gas & when I push the pedal to the floor It makes a popping or back firing noise.(this especially happens when I am going up a steep hill.I have had the fuel filter replaced & the air filter I have also tried fuel unjection cleaner. I have had the truck for 3 years & have never had it tuned up. Could this be the problem?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,118 Answers

Tune up would be a good place to start. most likely a bad plug wire or plug or both. tune up is in order.

Posted on Jun 27, 2009

  • jim1113543 Jan 06, 2011

    Mine has the 4.3 auto trand and it does the same thing but only occasionally. I have replaced the plugs, wires, distributor cap, fuel filter and air filter but no luck so far. I had it checked for codes but none were found.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Recently replaced clutch kit flywheel hydraulic slave cylinder on a 97 Chevy s10 4.3. Once the clutch system has been bled the clutch pedal pops off clutch master cylinder when pedal is hard. Any...


Not sure if I understand your question. Sounds like the push rod from the clutch master cylinder is pushing the cylinder off the firewall. If that is the case it could be that your rod wasnt fully engage into your cylinder make the rod to long and with enough pressure is popping the clip off the fire wall

Jan 12, 2015 | Cars & Trucks

1 Answer

1999 Chevy Blazer S10.. Won't start.. It was


sound you have a blown clutch slave cylinder

Dec 05, 2012 | Cars & Trucks

1 Answer

1990 toyota pickup v6 starts-up step on gas pedel motor then dies


does thr engine rev upwhen started than idels back down.try idel control switch and map sensor

Oct 27, 2012 | Cars & Trucks

1 Answer

How do you get the change oil light to go off?


Try stepping on the gas pedal 3 times with the key on but without the motor running. This should reset the oil change light. Make sure you go all the way to the floor when you push the pedal.

Nov 16, 2010 | 2000 Pontiac Grand Am GT

3 Answers

My 2000 chevy s10 pickup doesn't want to shift


Check your master and slave, If your slave is not fully depressing the pressure plate it would be very hard to shift.

Low fluid would not cause this. However there is a bolt on the side of the trans that you remove and put your finger in to check the level. If you put your pinky in and no fluid comes out it is low.

The slave often goes on the chevy's. It is internal, you have to pull the trans to replace it.

Also a pressure plate that is collapsing can cause the same problem. You are pushing all the way down, but it is not releasing.
Hope this helps.

Nov 03, 2009 | 2000 Chevrolet S-10

2 Answers

Need a 1996 1500 chevy 305 EXPERT!!!! ONLY!!!


Take an analog ohmmeter, remove connector from TP sensor, and touch probes on terminals of sensor, try combination of 2 until you see reading increase as gas pedal pushed & decrease as pedal released by someone, while engine off, and key off.. Have them slowly, & gradually push pedal, as you watch meter. Reading should increase slowly & gradually as well. If you see it climbing, then quickly drop off, then jump back up, it's faulty. Try to concentrate more on the position of gas pedal where you experience the engine cutting out. Costs nothing to try it.

Oct 16, 2009 | 1996 Chevrolet K1500

2 Answers

I have a 1998 chevy s10 it has a good brake pedal with the engine off but with it running the pedal go'es to the floor and you can hear air at brake booster


Check for fluid leaks and your brakes. If you see no leaks and your brakes are in good shape replace the brake master cylinder and bleed the system. The air you hear is because the pedal went to the floor. If the booster goes bad the pedal will get so hard you can hardly push it at all. I think you will find if this happened suddenly either you have a major leak or the master cylinder went bad.

Sep 29, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Chevy 1996 s10 pedal position code?


Another name for it is throttle position sensor. It is usually on the side of the throttle body, usually black in color, has a 2 wire connection, attached with 2 screws. Needs replacing.

Mar 16, 2009 | 1996 Chevrolet S-10 Pickup

1 Answer

1999 Chevy S10 Blazer 4x4. Replacing rear pad's,& Bleeding Breaks


have one person in the blazer pumping the brake pedal and then hold to the floor, crack the bleeder then tighten, release pedal, repeat till all air is out one side at a time, if this does not work then your ABS unit is bad witch if u follow your lines from your master cylinder u will find a black box with a motor on it, or the master cylinder itself is bad, it also can cause u to have no pedal, replace the master cylinder first, most likely cheaper.

Mar 11, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

1992 chevy s10 pickup


the brake switch just pushes into the holder...its under the dash if you follow the brake pedal up toward the bottom of the dash you will see it touching the metal above the brake pedal pad.

Jun 29, 2008 | 1992 Chevrolet S-10

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...