SOURCE: Airbag light indicator: Jeep Grand Cherokee 1997
there are many sensors and and each airbag have sensors so you will have to get it scanned to know where to start. just a note air bag parts can be very expensive so check out your local salvage yard. they can save you hundreds. good luck
paul
SOURCE: Headliner falling in my 1997 Jeep Grand Cherokee with center console thing
You can try to use the spray contact adhesive
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: replace fuel filter on 1997 jeep grand cherokee
If you have the V8 engine, the filter is actually part of the fuel pump. WHICH IS IN THE TANK
SOURCE: 2001 Jeep grand cherokee motor knock 4.7 motor
First, if the noise is from the upper part of the engine and is more of a tapping than a knock, likely you have a problem in the valvetrain, most often a bad lifter or worn rocker arm. If the noise is low, deep inside, the noise is from a bearing. This is generally accompanied by lower than normal oil pressure. Regardless of the underlying cause, correcting the cause will not stop the knock. To do that correctly, the engine needs to be removed and all crankshaft bearings and the crankshaft itself need to be replaced (crank can sometimes be "undercut" and thicker bearing shells can be used depending upon the amount of wear.) If caught very early, sometimes only one bearing can be replaced in-car, but in 99% of all cases I have ever seen, most will fail again, sometimes more severely if done this way.
Testimonial: "Thanks"
96 views
Usually answered in minutes!
×