SOURCE: engine timing for a 1998 subaru forester with a 2.5
Since ignition timing is taken care of by the ECU, I guess you are asking about cam timing.
There are several marks to be aligned and if you get them wrong, you may trash your engine so I am only going to suggest you buy a Haynes service manual that has numerous good pix that show you exactly how to avoid killing your engine.
And, unless you have a good-size vice well-mounted, compressing the belt tensioner again is going to give you fits.
The Haynes number you need is 89100 but it is listed only as a manual for the Legacy which uses the same engine but there may be less info that is usable on your '98 forester for which Haynes does not make a specific manual.
The later book that I have, 89101, covers all models from 2000 to 2006.
SOURCE: Subaru Forester window air leak
take out the tweeder covers if you have tweeders or remove the triangle covers were the tweeders woud be ,then stuff a klittle foam in their,worked for me
SOURCE: subaru forester heater
take back to the dealer,hopefully the will find that the blend door cable is off or not adjusted properly
SOURCE: Procedure for replacing rear wheel bearings 2000 Forester
i'm assuming you don't have a hubshark,this is a tool that will alllow you to remove the bearing while the knuckle is attached to the car,you may be able to rent this tool at a auto prts store .if not you need to remove the entie knuckle,first remove the trailing arm bolt,then the lateral link bolt{long and stubborn bolt},disassemble the brake shoes and parking brake cable,abs sensor if equipped the knuckle to strut bolt{no marking necessary they are not eccentric} then you need a to use or borrow a press to remove hub and bearings good luck
SOURCE: Installing replacement side mirror on 2007 Subaru Forester
yes... you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can access the bolts holding the mirror on and disconnect the wiring harness as well..
22 views
Usually answered in minutes!
×