Question about 2003 Chevrolet Malibu

2 Answers

Turn signal keep clicking randomly 03 malibu

My 03 malibu the turn signal just keeps clicking, even when I am not turning, or after the turn signal is turned off

Posted by on

  • Greg Bernett
    Greg Bernett May 11, 2010

    Relay/flasher may be bad or your turn signal cam/assembly is cracked...

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

To diagnose: Does the clicking resume to normal when the turn signal or hazrds on? Then:
Multi function switch is damaged.(seems to be common) This unit consists of the two control arms(turn signals and wiper control) on either side of the steering column. It is easily replaced. Cost, app. 200 from GM or 160 aftermarket. GM product is TRW assembled in Mexico. Aftermarket is made in Taiwan. Firstly:

Disconnect battery.

There are 3 #20 Torx screws under the steering column shroud. Remove them and carefully separate shroud and remove. It takes a bit to worm the shroud around the column tilt lever. I didn't check but you may not even have to remove the lower section.

There is 1 #20 torx screw on top holding the MFS in place. It also has 2 guide pins on the bottom. Remove the screw and disconnect the 3 electrical pin connectors. Now remove and replace with new unit. I did notice the steel pin that operates the horn(it pushes in and out and sits against a rotating plate in front of the steering wheel) was a bit rough so I smoothed it out with a small file. Now put everything back in place.

Anyway, that should take care of the clicking. It worked for me.
rough so I smoothed it out with a small file. Now put everything back in place. Anyway, that should take care of the clicking. It worked for me.

Posted on Aug 16, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

It is one of two things . the first thing is to change the turn signal flasher, if problem persists then you need a turn signal switch. First one cheep, second is not.

Posted on Jun 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2004 malibu classic my problem is the turn signal is keeps on clicking and clicking


Most of the time the problem is the 4 way flasher switch located in the dash, the signal flasher is part of this switch so replacing the 4 way flasher switch solves the problem.

Mar 23, 2013 | 2004 Chevrolet Malibu

1 Answer

03 ford f250 7.3 power stroke keeps blowing turn signal fuse.


Electrical issues are always a bit difficult to diagnose. Since I have not heard the wiring harness to be an issue on these, I would first look into if there was some add on causing an issue. Did you or someone add a trailer harness? Some type of additional lighting (like an LED bar)? Even possible a radio or under dash work? If not then do a once over and look at where the wiring comes through the firewall, or through the body to feed the turn signals. You just have to systematically follow the wiring from the lights back to the switch until you find the culprit. Let me know what you find and I can try to assist further.

Jan 03, 2013 | 2003 Ford F250

1 Answer

My 2002 chevy malibu's radio seems to be shorting out, the radio will work fine but randomly the sound shuts off the radio still shows the radio station and even says which artist is playing but there...


I'd suggest using the balance and fade controls to cut out each speaker one by one. to possibly determine if you have shorted speaker or speaker wiring. As far as the turn signal clicking noise, the hazard switch is the actual flasher unit for the turn signals, and could be the culprit, but the most likely cause is the turn signal switch itself. It is usually caused by corrosion across the contacts, which can be cleaned out fairly easily, but more typically, the switch is just replaced

Jun 16, 2011 | 2002 Chevrolet Malibu

1 Answer

Turn signal keeps clicking randomly Pontiac grand am 2002


This can either be caused by the hazard switch located above the radio or the turn signal /multfunction switch on the steering column.When it is doing this try wiggling the turn signal switch and see if it stops. If it does stop the issue is most likely in the turn signal switch.

Apr 20, 2011 | 2003 Chevrolet Malibu

2 Answers

Turn signal clicker comes on randomly but doesn't affect lights


No the dash is the hazard light switch, it's also the turn signal flasher, dealer part only replace, replacing it will fix your problem. Feel the switch when you hear the clicking.

May 21, 2010 | 2004 Chevrolet Malibu

2 Answers

TURN SIGNAL NOT FLASHING INTERMITTENTLY


no remove lower cover only. good way to find is trun on signal and listen for clicking,hope this helps,note there are two one for signals and the other for hazards.

Oct 08, 2009 | 2003 Chevrolet Malibu

2 Answers

Clicking Noise similar to turn signal


sounds like a bad turn signal relay

Sep 09, 2009 | 2001 Chevrolet Malibu

1 Answer

Turn Signals


DOES THE LIGHT FLASHES REALLY FAST ?
IF IT DOES TURN THE SIGNAL ON EITHER LEFT OR RIGHT AND IF ITS FLASHING REALLY FAST ON THAT SAME SIDE THEN CHECK ALL YOU BULBS BACK FRONT OF THE VEHICLE ONE IS BAD

Aug 20, 2009 | 2003 Chevrolet Malibu

2 Answers

2003 Chevy Malibu. While driving down the road turn signal keeps clicking randomly.


what this means that either you have a short in the wire harness going to the turnsignal/dimmer switch assembly . or the switch contacts inside the dimmer switch itself are shorting. this would be a good place to check for the intermitant problem

May 09, 2009 | 2003 Chevrolet Malibu

Not finding what you are looking for?
2003 Chevrolet Malibu Logo

2,084 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8195 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...