Question about 1998 Ford Windstar

1 Answer

Where is the oil sending unit located on my 1998 ford windstar 3.8 engine?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 37 Answers

In a really stupid place. It is sticking out of the side of the timing cover right below the power steering pump bracket. It is really fun to try to get at. Advise? Go to an expert.

Posted on Jun 27, 2009

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wyatt1582
  • 453 Answers

SOURCE: Where is the oil sending unit on a Windstar 1998

Should be close to the oil filter. It will be a metal tube sticking out with 1 wire running to a pod at the end of it.

Posted on Apr 22, 2009

  • 98 Answers

SOURCE: where is oil pressure sending unit?

lower right hand side, front of engine, below the power steering bracket.

Posted on Nov 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 ford windstar engine smoking from back center of engine as you look at it. smoke smells like oil somewhat. oil levels are fine, no white smoke from exhaust, could it be oil sending unit? Help me...


engine probly has some worn hardware or hoses--chec oil for any foaming to eliminate bad gaskets--valve guides or rings cud hav minor wear causin some burnt oil smell thru leakin exhaust

Nov 29, 2011 | 1998 Ford Windstar

1 Answer

My 1998 windstar just lost oil presure ,all oil pressure


If the engine runs quiet the gauge in the dash or the oil sending unit is bad. generally the sender on the engine goes bad from the heat of the engine. If the engine makes all sorts of noises and rattles inside the oil pump is shot

Mar 31, 2010 | 1998 Ford Windstar

1 Answer

O2 sensors on 1998 ford windstar


1998 Ford Truck Windstar 3.8L SFI 6cyl, there are 4 oxygen sensors on the Windstars They are divided into 2 banks of 2. Bank 1 is the for the rear 3 cylinders of the engine - Bank 2 is for the front 3 cylinders. Bank 1 / Sensor 1 (upstream) is located just below, in the pipe, the exhaust manifold on the back of the engine.

REMOVE TIP: you may have to bend part of the transmission heat shield out of the way - be sure to put it back when done.
Bank 1 Sensor 2 (downstream) is located just past the drivers side catalytic converter.
Bank 2 Sensor 1 (upstream) is located just below the exhaust manifold, in the pipe, at the front of the van - access is from the top.
Bank 2 Sensor 2 (downstream) sensor is located just past the passenger side catalytic converter.

NOTES: * Use lots of penetrating oil - allow to soak - to make removal easier and avoid damaging the exhaust pipe

Hope this help; TY for using Fixya (remember rated and comment this).

Mar 30, 2010 | 1998 Ford Windstar

1 Answer

Where is oil pressure sending unit?


lower right hand side, front of engine, below the power steering bracket.

Nov 07, 2009 | 1998 Ford Windstar

1 Answer

Where is the oil sending unit on a Windstar 1998 3.8 engine?


Should be close to the oil filter. It will be a metal tube sticking out with 1 wire running to a pod at the end of it.

Apr 22, 2009 | 1998 Ford Windstar

2 Answers

Location of the Oil Pressure Sending Unit on a 2001 Ford F-150 V-6 4.2 liter


On the drivers front of engine block below the cylinder head & gasket . Slightly behind waterpump.

Apr 14, 2009 | Ford F-150 Cars & Trucks

1 Answer

No Oil Pressure


did you check the synchronizer assy? It is the piece with the cam sensor on top in place of the distributor. These have a tendency of breaking. It also drives the oil pump.

Jan 16, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
1998 Ford Windstar Logo

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...