Question about 1996 Chrysler Concorde

2 Answers

My 2001 chrystler concord will turn over but wont start

I recently got this car. it was driving fine untill i noticed that it was running low on oil. i solved the oil problem but now the car wont start.

Posted by on

  • 2 more comments 
  • donavangolds Jun 27, 2009

    yes it does turn over but wont start up

  • donavangolds Jun 27, 2009

    my car turns over but fire

  • donavangolds Jun 27, 2009

    sorry my car will turn over but wont fire

  • yadayada
    yadayada May 11, 2010

    are u sure u didn't toast the engine bearings?

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 14,036 Answers

Take a 1/2 rachett wrench with deep socket.find what size crank shaft pulley bolt you have.when you have the right size socket try to turn crank shaft clock wise.if engine wont turn.your engine seized lack of oil.if engine turns over.your cylinder wall can be scorned enough to cause no compression.no compression engine will not crank.

Posted on Jun 27, 2009

  • Jonah Oneal Jun 27, 2009

    scan it to see if cam sensor or crank sensor is working . if not the automatic shutdown relay will shut off ignition coil and fuel pump.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 314 Answers

Check and make sure that the engine is not seized up. Does the engine turn over?

Posted on Jun 27, 2009

  • Charles Moore Jun 27, 2009

    then you are having a problem with the ignition system if you donnot have a spark. Test the different parts with a multimeter and see where the voltage stops.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Concorde clicking start or wont start


-You mean click but no crank (Turn over).
If so. Need new starter.

Mai

Nov 11, 2013 | 2000 Chrysler Concorde

1 Answer

My 94 chrystler concord turn over but wont start


well it could be the sparkplugs or sparkplug wires the distriutor cap or rotor fuel filter could be clogged air filter could be dirty

Aug 06, 2012 | Cars & Trucks

2 Answers

2001 Chrysler concorde 2.7 car wont but turns over. If I disconnect the cam sensor the car will start. ????


No. The 2.7 is noted for having the timing belt break. It will roll over but not start. Must replace timing belt.

Feb 29, 2012 | 2001 Chrysler Concorde

3 Answers

My low oil light comes on while trying to crank my car and car stalls; will not start until I keep trying a couple of times. After it starts it runs fine and then shuts off after backfiring sometimes and...


LOW OIL PRESSURE WILL CAUSE OIL PRESSURE SWITCH OR SENDING UNIT TO DISABLE FUEL PUMP.CHECK FOR OIL PRESSURE.REMOVE OIL PRESSURE SENDING UNIT SCREW IN OIL PRESSURE GAUGE TESTER INTO BLOCK WHERE OIL PRESSURE SENDING UNIT GOES TURN ENGINE OVER CHECK FOR OIL PRESSURE SHOULD BE 18 PSI @ 2000 RPM. BESURE TO WRAP TEFLON PLUMBERS TAPE AROUND THREADS TO THE OIL GAUGE PRESSURE TESTER OIL WILL SPRAY EVERY WHERE.IF YOU ARE GETTING NO OIL PRESSURE.YOUR OIL PUMP FAULTY.YOUR ENGINE CRANKSHAFT BEARINGS WORN OUT.WORN DAMAGED CAMSHAFT OIL PUMP DRIVE GEAR OR OIL PUMP DRIVE ROD DAMAGED OR BROKEN. IF OIL PRESSURE OKAY OIL PRESSURE SENDING UNIT IS BAD.

Sep 28, 2011 | 1994 Chevrolet Caprice Classic

1 Answer

2001 Jeep Grand Cherokee Laredo approx 147000 miles. Recently notices oil pressures going up to 80psi periodically when driving. If I turned off the engine and restarted it would read normally. Within...


Very first thing you need to do is install a mechanical pressure gauge on there to verify what you see on your gauge. If the actual pressure is low, then it's time to start looking inside the engine. If not, then you need to trace out the electrical problem but will know the engine is safe.

Jan 29, 2011 | 2001 Jeep Grand Cherokee

1 Answer

My digital ac switch does not light up or turn on my ac on my 1994 chrystler concord why?


COULD BE A COUPLE OF PROBLEMS. FIRST, AND MUST COMMON. THE FREON LEVEL MAY BE LOW (LEAK). SECOND, THERE MAY BE AN ELECTRICAL PROBLEM. CHECK FUSE UNDER DASH, AND FUSES UNDER THE HOOD.

Jul 03, 2010 | 1994 Chrysler Concorde

1 Answer

94 Chrysler Concorde Tranny Problems


Have your transmission oil filter changed;
it is located under the transmission pan
The oil is what makes the transmission shift
When you shut off the engine it stops the transmission pump then when you start up again the transmission shifts until the filter clogs again

May 28, 2009 | 1994 Chrysler Concorde

2 Answers

2001 concorde dont start


Check the cranshaft position sensor located under the timing cover. Also check the camshaft sensor located near the camshaft.

Feb 06, 2009 | 2001 Chrysler Concorde

2 Answers

OIl pressure light flickers


change the oil pressure switch or the wrong oil

Jan 18, 2009 | 2001 Chrysler Concorde

2 Answers

Oil in the radiator


cylinder head gasket it can be or water seals in side the cylinder head,

Sep 27, 2008 | 2001 Chrysler Concorde

Not finding what you are looking for?
1996 Chrysler Concorde Logo

510 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...