Question about 1999 Chevrolet Venture

2 Answers

Need to change an engine in my van.

Can a 1998 chev lumina 3.1 V6 fit in a 1999 chev venture 3.4 V6?

Posted by on

  • Ot Tap
    Ot Tap Jun 13, 2012

    There is a lot of changes to be done but yes it will work.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Why are you swapping an older model engine with your new model vehicle it's not very compatible with an older engine. Components like the transmission ECU and other electronics parts will not be a proper match.
I would suggest to buy a 99 model Chevrolet venture engine that you can find with an online dealer like Rebuil engine @ Hiperformer, among others.

Posted on May 29, 2013

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

Yes they will swap out ,most have same sensors and all ,check the plugs on wiring harness before you swap them out make sure,im sure you can cause they both will work in there. hope to help you, thanks robert b.

Posted on Jun 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Firing order for 1997 chev.Lumina 3.4 v6 need a diagram


From left to right facing vehicle from front.-- coils are, 5-2-3-6-4-1 Engine from backside left to right is--1-3-5, engine front left to right is 2-4-6, #1 goes to #1 on coil pack etc, Good-Day!

Aug 08, 2014 | 1997 Chevrolet Lumina

1 Answer

Pcv valve chevrolet lumina


I've had the 3100 v6 chev lumina car but not the van, the pcv valve is located in the front valve cover to the right hand side.



bc8a81e1-be09-442e-87eb-dcb2e93029b7.jpg

Apr 27, 2014 | 1995 Chevrolet Lumina

2 Answers

Do i have to go under the van to access the plugs on the backside of the enging?...sideways V6.


no its not easy but i always do them from the top it helps to have different length extensions and swivels

Aug 12, 2013 | 2002 Chevrolet Venture Passanger

2 Answers

My 1992 chev lumina apv van stalls everytime i put on the brakes at every red light it restarts after no codes are coming up what could it be?:


check to make sure the power brake booster is not leaking, do this by starting the van and just let it idle in park and push the brake pedal if the engine stalls or surges or you hear a sucking noise under the dash then replace the power brake booster if there is none of these systems then replace the idle control motor. GOOD LUCK

Mar 08, 2011 | 1992 Chevrolet Lumina APV

2 Answers

Car wont start


Probably a bad starter activator find it and tap on it sometimes it will kick the starter, but it means the starter will have to be replaced.

May 10, 2010 | 1999 Chevrolet Venture

1 Answer

I have a 1983 Toyota Hiace Commuter Van with a 3Y motor in it. I want to put a V6 in it. Which V6 will fit in the engine bay


A Toyota v6 out of a hilux 4runner will go in and be about half again the power and torque. Should be able to fit a 2wd transmission off the van to it. Or here in Nz and Australia the Holden 3.8 v6 is a very popoular conversion. Use the holden trans and modify the drive shaft to suit. Holden v6 is a rear wheel drive version of the Buick v6. Also seen Toyota 1UZ and Chev v8s fitted in without cutting metalwork, so room is not as much of an issue as you would think!

Nov 02, 2009 | 1985 Toyota Passenger

1 Answer

For my 1998 Chev Venture I had the exaust system replaced from the catalytic converter on (original problem was tailpipe broke off after the muffler) and the next day got a check engine indication that the...


If high mileaged could probably be a cat. But more liklly sounds like a sensor. Vibration from removal may have done something. But I wouldnt blame the shop for it. After all it is an older van

Jul 30, 2009 | 1998 Chevrolet Venture Cargo

1 Answer

How to replace a key lock cylinder on a 99 chevy lumina v6 3.1


how to replace the key lock cylinder in 99 chev lumina. it has a chip in the key

May 09, 2009 | 1999 Chevrolet Lumina

2 Answers

Where is the thermostat located on a1999 lumina v6?


Grab top radiator hose, and follow back to engine. The part the hose is clamped to is the thermostat housing.
Remove the hose, and 2 bolts for the housing and the thermostat is revealed.

Jan 20, 2009 | 1999 Chevrolet Lumina

1 Answer

Lumina van engine swap


i think you have to change the computer two

Sep 04, 2008 | 1995 Chevrolet Lumina

Not finding what you are looking for?
1999 Chevrolet Venture Logo

Related Topics:

178 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...