Question about 2004 Hyundai Santa Fe

1 Answer

No water at all coming out

I can hear the pump going when i pull the lever to clean the windshield but nothing will come out at all.

Posted by on

  • cy schousboe May 11, 2010

    Is the resevoir full? If so , your line is pbobably off or cut. Make sure it is connected at the pump and the washer nozzles. If it's connected, have some one pull the lever while you watch under the hood and the leak should become evident. Vacuum line at your local parts store will fix that.



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 25 Answers

Refill the bottle? if it is full either the hoses are blocked/plugged if empty the bottle is leaking

Posted on Jun 27, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My windshield washer is not working correctly.

Assuming you have washer fluid and you can hear the pump with no flow at the main line I would guess the turbine has separated from the pump shaft.

Sep 30, 2014 | 2006 Ford Focus

1 Answer

How to find the windshield washer fluid pump fuse on a 2012 VW Jetta

Did they connect the power to the pump?
yes it could be a fuse.

Mar 14, 2014 | 2011 Volkswagen Jetta

1 Answer

Windshield Washer Pump connection to the water bottle

Take the rubber hose loose at the nozzle, try the washer. if water comes out then the little hole in the nozzle is stopped up. Use a small needle or stickpin to clean it out while someone works the washer switch.

Nov 27, 2017 | 2005 Chrysler Pacifica Touring

1 Answer

2008 Ford Focus Windshield Washer Fluid level is full but it does not spray on windshield. Had it in for service and they cleared the lines, but it still won't spray on windshield. It cost a lot of money...

check the water pump placed under the water bottle or switch the car on dont start it run the water if you dont hear the sound of water pump running its either the pump damaged or something to do with the fuse or wiring

Jan 25, 2011 | Ford Focus Cars & Trucks

1 Answer

My rear windshield fluid is working but my front is not. I can hear the pump running for the rear but not the front. The wipers come on but nothing comes out. I have a 1997 jeep Cherokee

one of the lines may be clogged.take them off and check them run water through them and if it wont go through then you need to but new hoses/lines.

Dec 08, 2010 | 1997 Jeep Cherokee

1 Answer

I have a 2005 Hyundai Tiberon. The washer fluid jets seem to have stopped working. It's full of fluid, but when i pull the lever for it to squirt onto the windshield, nothing comes out. Just wondering...

lift up the hood and remove a washer pipe,if fluid pumps out then its just the jets blocked,(use an airline/thin pin to clear.if fluid does not come out,check the pump.

Nov 15, 2010 | 2005 Hyundai Tiburon

1 Answer

I need to clean my windshield some times well driving and I don't know where the button is located at to spray the windshield washer fluid.

you have two levers on the steering column, one for the lights and the dipper and the other to run the windshield wipers and also if you pull this up, it will pump up some windshield washing fluid. On a dry windshield first pull it up and release three or four times and then run the wiper blades and not on a dry glass as it will leave scratches.

Jan 26, 2010 | 1989 Dodge Dynasty

1 Answer

Windshield fluid will not pump when I pull the lever.

the small motor attached to the windshield water reservoir is stuck or is rusted. try removing it and put oil on it.

Aug 12, 2009 | 2004 Kia Sorento

1 Answer

The water for the windshield doesn't come-out from the reservoir... can you helpme with this...thanks.

Usually this is caused by (1) clogged tubes leading to windshield (2) no power to little pump in the water tank or (3) pump malfunction. It could also be a switch malfunction --but that is less likely. If the car is old, it is probably clogged tubes. If so, you have to take all the tubes off and clean them, including the little nozzles--and clean the tank.

Jul 09, 2009 | Dodge Caravan Cars & Trucks

1 Answer

Windshield wiper fluid won't squirt

When you pull the lever to activate the windshield washers, do you hear any type of sound coming from under the hood?  A whirring sound should be heard from the little electric pump that feds the washers.
If you can hear the whir, then you should look for a possible clog in the washer hoses (there is more than one...).
If you cannot hear the whirr, then you should check the fuse that protects the windshield washer circuit.  Check your owner's manual for the location and correct amperage for this circuit.
Good luck!

Jun 16, 2009 | 2007 Mercedes-Benz C230 Sedan

Not finding what you are looking for?
2004 Hyundai Santa Fe Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides