Question about 1998 Chevrolet S-10 Pickup

1 Answer

HOW DO I REPLACE THE FUEL PUMP ON 2003 CHEVY S10 PICK UP

Posted by on

  • Anonymous Mar 12, 2014

    Replace the trans shift sensor on a 86 Chevy s10 pick up

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,984 Answers

Removal & Installation To Remove:

  1. Properly relieve the fuel system pressure.
  2. Drain the fuel tank through the filler pipe.
  3. Support the fuel tank.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Filler neck
    • Shield and tank straps
    • Fuel lines and vapor hose from pump and tank
    • Electrical connection from fuel pump
    • Fuel tank
    • Fuel pump/sending unit assembly by turning the locking ring (located on top of the fuel tank) counterclockwise using a spanner wrench
    • Fuel pump from the fuel lever sending device
To Install:
  1. Install or connect the following:
    • Fuel pump in tank with new seal around opening
    • Tank and connect fuel lines and vapor hose
    • Tank to the frame
      1. Torque to: 33 ft. lbs. (45 Nm)
    • Shield
    • Fuel filler neck and clamp
    • Negative battery cable
  2. Refill the tank.
  3. Run the engine and check for leaks.
HOW DO I REPLACE THE FUEL PUMP ON 2003 CHEVY S10 - 1e2538e.gif

Posted on Jun 26, 2009

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: I need to replace the fuel pump in my 1985 Chevy S10 Pickup.

EXACT PROCEDURE ! Please Rate Me Fairly for this!! Thank you And Good Luck !!


ELECTRIC PUMP

REMOVAL

  1. Before servicing the fuel pump the fuel system pressure must be relieved. See: Fuel Pressure Release
  2. Disconnect the negative battery cable.
  3. Raise the car on a hoist.
  4. Remove the fuel tank. See Fuel Tank / Service and Repair.
  5. Remove the fuel tank sending unit and pump assembly by turning the cam lock ring counterclockwise. Lift assembly from the fuel tank.
  6. Pull the fuel pump up into the attaching hose while pulling outward away from the bottom support. Take care to prevent damage to the rubber insulator and strainer during removal. After the pump assembly is clear of the bottom support, pull the pump assembly out of the rubber connector for removal. NOTE: Inspect the fuel pump attaching hose for any signs of deterioration. Also check the rubber sound insulator at the bottom of the pump. Replace damaged or deteriorated parts.
INSTALLATION
  1. Push the fuel pump assembly into the attaching hose.
  2. Position the fuel tank sending unit and pump assembly into the fuel tank. Use a new "O" ring seal. NOTE: Care should be taken not to fold over or twist the strainer when installing the sending unit as this will restrict the flow of fuel. Also, verify that the strainer does not block the full travel of the float arm.
  3. Install cam lock over the assembly and lock by turning clockwise.
  4. Reinstall fuel tank.
MECHANICAL PUMP

REMOVAL and INSTALLATION

NOTE: To ease pump installation, rotate the camshaft so the camshaft eccentric is out of the way of the fuel pump rocker arm.

  1. Disconnect fuel lines from fuel pump.
  2. Remove fuel pump mounting bolts and the fuel pump.
  3. Remove all gasket material from the pump and block gasket surfaces. Apply sealer to both sides of new gasket.
  4. Position gasket on pump flange and hold pump in position against its mounting surface. Make sure rocker arm is riding on camshaft eccentric.
  5. Press pump tight against its mounting. Install retaining screws and tighten them alternately.
  6. Connect fuel lines. Then operate engine and check for leaks.

Posted on Mar 22, 2009

  • 2309 Answers

SOURCE: fuel pump location for chevy s10 1998 pick up 4WD

inside the gas tank, with the sending uit

Posted on May 10, 2010

Testimonial: "thank you very helpful"

  • 79 Answers

SOURCE: how much should it cost to replace the fuel pump

i just bought one for 198.00 and put in my self take bad off it much easier at autozone.

Posted on Jul 31, 2010

  • 7353 Answers

SOURCE: i have 94 chevy s10 pick up 4cyl with a 6cyl fuel

YES......they are NOT interchangeable. the 4 cyl uses 41-47 psi, the 4.3 "W" uses 9-13psi and the 4.3 'Z" 55-61psi

Posted on Sep 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have 1997 chevy s10 pick-up recently replaced fuel pump and i keep blowing the #20 ignition fuse


On the chevy truck fuel pumps the plug at the end of the wires that attach to the pump go bad. Cut off and splice in a new one . cost about $10

Jan 31, 2017 | Chevrolet S 10 Cars & Trucks

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Having problem with my fuel pump the no power getting to it. i check the fuse and they are all good. this is a 2003 chevy silderado


I HAVE A 96 S10 LT BLAZER AND RESCENTLY DID THE FUEL PUMP THERE SHOULD BE A CLASS ACTION LAW SUITE GM . THERE WERE 14 HOLES IN THE TOP OF MY GAS TANK WITH THE NEW DELPHI PUMP OEM STANDRED SERVICE BULLETIN #25215705 DATED 3 07 STATES YOU NEED TO REPLACE WIERING HARNEST TO FUEL PUMP DO TO FIRE HAZARD CAUSED BY OVER HEATING

Oct 11, 2010 | Chevrolet Silverado 1500 Cars & Trucks

2 Answers

How much should it cost to replace the fuel pump in a 2000 chevy s10 pick up?


$660.00 for the pump (might find a cheaper one but some are junk, be careful), 1 - 2 Hours labour @ whatever local rate.

Jul 30, 2010 | 2000 Chevrolet S-10

1 Answer

Have a 1992 chevy S10 with a 4.3L it cranks over but it don't start. i checked pick up coil it's good. i checked ing. coil . it checks good. and icontrol modgual with a ne have a 1992 chevy S1with a 4.3L...


Try this. Remove the breather, Carefully tip 1/2 a cup of gas in the intake. Replace the breather quickly. Fire it up. My quess is that it will run fine. The fuel pump is the prob! You will need to lower the fuel tank to change the fuel pump.

Mar 26, 2010 | 1992 Chevrolet S-10

1 Answer

My husband said his 2000 Chevy S10 would sputter and stall continuously. Just happened yesterday. Took it to Pep Boys. They diagnosed it as a bad fuel injector. He has a 4 cyclinder manual transmission....


I had the same problem with my 1992 S10 Pick Up. Found the problem to be with the fuel pump. Replaced the fuel pump and it ran like a charm.
The fuel pump is located in the gas tank.

Sep 15, 2009 | 1992 Chevrolet S-10

2 Answers

2003 chevy pick up 2.2l s10 turns over but won't start has spark but no gas getting up to the injecktis only 50,00 miles on it it just stop runing and how do I fix it


if you take a hammer and hit the gas tank flat side of hammer, while someone else is turning it over. it should start. if it does start the fuel pump is shot.

Jun 26, 2009 | 1998 Chevrolet S-10 Pickup

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

4,557 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...