Question about 2005 Dodge Durango

1 Answer

Where do i find the egr valve on my 2005 durango?

How do I tell if it just needs to be cleaned or if it needs to be replaced?

Posted by on

  • yadayada
    yadayada May 11, 2010

    what engine?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

You dont but a new gasket is only a couple dollars so take it off clean it and put it back on you will need some really small brushes to get in were the moving parts are you have to get the crud off the little sliding shaft inside

Posted on Jun 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Number #3 cylinder not firing


Pcm is very rarely the cause of a misfire. Get another opinion. Check plug and wire, then coil.

Jul 16, 2017 | 2005 Dodge Durango

1 Answer

What causes the truck to shut down but it will crank right baxk up


our 2005 durango would do this and it is a sticking EGR valve..pull it and clean it or replace it

Mar 19, 2012 | 2005 Dodge Durango

1 Answer

How to replace the egr valve on a 2005 dodge durango 5.7 hemi


Dont bother just make a seal off gasket from a coca cola can ,it will run better without the EGR valve and still pass the emmisions test with it blocked off

Apr 25, 2011 | 2005 Dodge Durango

1 Answer

How do I install an EGR valve for 2005 dodge durango?


To install the EGR Valve on a 2005 Durango first it is necessary to remove the air intake hoses and palce them to the side. Next, in order to get the EGR valve you will need to remove the windshield wiper motor, which is a pain but necessary to do get to the EGR valve. After removing all of the itemsthat are in the way you will be faced with a task that will try your patience, the EGR valve is located on the right side of the motor, (as if you were facing the motor from the front) just behind and to the rear of the throttle body. After you locate it you will need a rachet with a flexible head because it is fairly difficult to reach otherwise. A mirror and light will also help so you can see what you are doing since the EGR valve is located in such a hard place to see and get to that you will only be able to see part of it while you are removing the screws. After removing the EGR valve, simply reversethe procedure and your done. P.S. I own a 2005 Dodge Durango SLT with a 4.7L engine and I replaced mine this year after a check engine light came on and I checked the code on the OBD. By the way the EGR valve is a pain in the rear to change. Good luck!

Jun 29, 2010 | 2005 Dodge Durango

1 Answer

EGR Valve 2005 Dodge Durango


Check in the drivers side rear of engine take off the air housing and use 13mm. deep socket w / 3inch ext. and air ratchet to remove 2 bolts, then take tire off inner splash panel then 8mm wobble w / 24inch ext to take 1 tube bolts loosen other one and pull out as ***. Reverse to install.

Hope this help to solve it (remember rated this post).


May 20, 2010 | 2005 Dodge Ram 1500

1 Answer

Need to locate EGR valve on dodge durango 2005


EGR VALVE LOCATED ON THE INTAKE.IT HAS A SMALL ROUND LOOKINGIT HAS A METAL FLEXIBLE PIPE THAT CONNECTS TO THE EXHAUST MANIFOLD.

Feb 01, 2010 | 2005 Dodge Durango

1 Answer

05 Dodge caravan P0406 code


It is most likely that your egr needs to be replaced

Jan 10, 2010 | 2005 Dodge Durango

2 Answers

Egr valve dodge durango


if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.

Apr 17, 2009 | Dodge Durango Cars & Trucks

1 Answer

Location of EGR valve on 2005 Dodge Durango


If I had been him, I would have talked you into a Chilton or Haynes manual for your car. They are easily detailed enough to show you the location and  Iwould be surprised if a chain operation like AZ didn't have the right one on hand.

Dec 10, 2008 | 2005 Dodge Durango

Not finding what you are looking for?
2005 Dodge Durango Logo

Related Topics:

241 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...