Question about Ford Bronco

1 Answer

When driving any speed bronco is shaking,when i take my foof of the gas sheking stop

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,

Wires by the fuel pump relay probably have IGS corosion. Check all these wires carefully.Regular maintenance is 50K miles. If system is scanned with computer device and the sensor does not switch voltages (lo to hi mv ) it's also time to change it.It does sound like the driveshaft threw a weight off and is out of balance.

Thanks for contacting Fixya

Posted on Jun 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 durango shakes at 45


Hi,
What was serviced a few weeks back? Sounds like it needs a tune-up @ least to start - spark plugs, plug wires.

At 103K miles I'd also replace the fuel filter, air filter, PCV valve. And if you look in the Owner's Manual it should have a maintenance schedule for other items that may need attention.
GL,
TD

Mar 14, 2014 | 2004 Dodge Durango

2 Answers

I have a `92 ford bronco xlt with a 351w and the e4od. when i`m driving down the road and let off the gas, i get a very loud chattering noise. it doesnt do it all the time but if im coasting and i shift...


A few months back, if you remember, did you hear a "squeak squeak " that got faster as you picked up speed, then went away as you went over 25 to 30 mph? if so replace your universal joints on drive shaft.

Mar 19, 2010 | Ford Bronco Cars & Trucks

1 Answer

I have a 1992 Camry V6. When I start up the car, it's fine. About 5 minutes into the drive, the car starts to shake when it's stopped. When I'm on the HWY, the car shakes when I hit 55-62mph. To stop...


The problem is in the transmission Overdrive gears. You need to have the transmission checked and probably serviced. It may be a simple adjustment or Fluid and Filter change. I do not recommend you all them to use a synthetic replacement however as most of the time I have seen this done the transmission burns within about 6 months.

Dec 02, 2009 | 1993 Toyota Camry V6

1 Answer

1988 Bronco 2 stalling out.


have te ignition module and stator been replaced? that is the common cause of this, and yes the engine being out of time can cause this stall out, when you time the engine remember you must remove the timing shorting bar at the distributor connector to the TFI ignition module or the timing will be severely retarded

Jul 17, 2009 | 1988 Ford Bronco II

2 Answers

91 Toyota Previa shaking and missing


you need to replace the fuel sock in the tank and the fuel filte and do a tuneup wires plugs and cap.

Jun 21, 2009 | 1991 Toyota Previa

1 Answer

My 2001 volvo s40 shakes when I accelerate past 30 mph


it could be a motor mount check the condition of it or it can be that something with the suspension might need attention . . those things can cause vibration at certain speeds

Jun 08, 2009 | 2001 Volvo S40

1 Answer

Shake problem


IGNITION COIL.

Dec 25, 2008 | 2001 BMW 5 Series

1 Answer

Car losses power at 55


sounds like a bad EGR gasket,, did you wash the engine when it was hot? if so replace EGR gasket

Dec 16, 2008 | 1993 Pontiac Bonneville

1 Answer

1995 Ford Bronco dies when coming to a stop.


The idle air control solenoid could be bad. give the engine a vacuum leak and see if that helps any

Oct 15, 2008 | 1995 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

155 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...