Question about 1986 Chrysler LeBaron

1 Answer

Electrical dash, speedo etc. - 1986 Chrysler LeBaron

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chrysler Master
  • 75,822 Answers

U will need to remove the dash assmbly and send it out for repair, there is a circuit board inside that runs the gauges that fails.

Posted on Jun 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The speedo keeps going to zero at the same time the radio sound goes quite


It could be a dash grounding problem. The ground for dash electrical is up under the dash, into the firewall.

Jun 11, 2016 | Cars & Trucks

2 Answers

Dashboard is dead


hello Sylvia i think you have had your dash board taken out at some
stage previous to your owning it, there is a big electrical connector
that hooks up to the printed circuit board behind your dash. you will
need to get a techy to pull off the plastic masks around your dash
and unscrew the speedo console. we used to get alot of this fault
here in New Zealand when sellers of vehicles were clocking the
speedo's to show a lower mileage reading on the odometer, very
nasty.
cheers bucky

Dec 31, 2012 | 2004 Cadillac Escalade

2 Answers

I have a 1997 buick le sabre with only 70k original miles... the speedometer works intermitently... now less and less... do I need to replace the whole instrument cluster? or is it a loose wire?? any...


you might want to check the speedo drive gears at the transmission and make sure they are in good shape and the gear that drives the electrical portion is spinning freely as any damage here will cause intermittent speedo operation.also if this is an electrically sent speedo from the tranny check the electrical connections.there is also a speedo buffer in the dash that rarely goes bad but is still a possibility.and lastly it could be the speedometer head thats the problem.when the speedo stops working does the odometer still work.if so then the problem is in the speedo head.i don`t remember which ones or what year they changed them but some you could just replace the speedo head and not the whole cluster assembly.

Jul 07, 2011 | Buick LeSabre Cars & Trucks

1 Answer

All warning lights on dash come on and all electrics stop working


The common problem with the dashes on the Jeep is contacts. Remove the cluster and try cleaning the electrical contacts with a Q-tip and alcohol replace cluster and try again.

Aug 02, 2009 | 1995 Jeep Grand Cherokee

2 Answers

Why would the dash gauges, (speedo etc.) stop working?


computer failed, or the connector has come out of the speedo head.

Jun 25, 2009 | 2006 Chevrolet HHR

1 Answer

Speed o keeps flickering


i would say it is the electrical sender on the gbox, trans, unless it continually drops to zero then i would say it is an earth problem in the dash but if it goes up over the spped you are doing then under etc etc, then the problem is the elec signal being sent by the speed sensor on the trans. hope i have been of some assistance.

May 15, 2009 | 1997 Audi A4

1 Answer

Speedo unit died then Fuel gauge went to max


the dash control board is the controler for the boards in the dash, fuel temp etc. inside the dash itself, a board on the rev counter controls voltage to feed the the fuel gauge etc. the back of the speedo burnt,there is the 3 pin voltage control chip on the board. you can replace the boards. you can remove them from another dash and place them into yours but if you say the board burnt out on the speedo . then i would just change the dash as it would be easier as you would need to replace the speedo as well. you will also need to inform dvla that the speedo has been changed as for mots its recorded. or have the speedo rectified to the right mileage. not informing dvla can affect your insurance.

Jun 30, 2017 | 1994 Audi Cabriolet

2 Answers

Speedo will not work with new sensor fitted


if you can try take off the dash and remove the dash unit and check to see if the speedo cable is attatched properly

Jan 10, 2009 | 1993 Toyota Land Cruiser

2 Answers

Ford transit van dashboard display not working


ive got a 55 plate 85 T260 swb crewcab 68000 miles, , i bought it 12 months ago, red light flashes on dash board most days, some times arratically, sometimes quite slow, and all clocks, speedo and dash does not work?????????
the smallest scratch and the van rusts, no under seal, there just a use it and dump it van.

i would just like to say fords are ****

Dec 27, 2008 | 2003 Ford Escort

1 Answer

Dashboard background lighting for speedo and revcounter etc


need to take panel off & dash unscrews...when taking panels off have to unplug....usualy few screw hold it & clips and abt 2-4 screws for dash

Dec 19, 2008 | 2002 Jaguar X-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...