Question about Avanti Studebaker

Open Question

2000 ford ranger wont start battery ok only hear cliking sound once and clicking sound under dash on right side

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 104 Answers

SOURCE: 98 ford windstar has clicking noise under dash and won't start

The clicking noise is most likly the starter solinoid cycling in and out. This is due to low battery voltage. charge the battery, then have the battery and charging system tested. Some auto supply stores will do this for free for you in the hopes of selling parts

good luck

Posted on Feb 09, 2009

cadman000
  • 607 Answers

SOURCE: Clicking noise under dash

I would change the oil and filter, including proper weight oil. Then I would test again after sitting overnight. Maybe you'll be fortunate and it was due to an overdue oil change. If it still persists, there might be a problem with a hydraulic lifter draining overnight

Posted on Apr 06, 2009

csmock132
  • 4669 Answers

SOURCE: clicking noise under dash

It likely has a bad temp control actuator for the blend door.

Posted on May 27, 2009

  • 30 Answers

SOURCE: I have Ford Ranger Supercab 2001. The 4wd does not

When you turn the dial to 4 wheel drive it controls a solonoid unit that then controls the electric motor that shifts the trasfer case to 4X4. The clicking sound that you are hearing is probobly the solonoid unit (4x4 control unit) engaging or trying to engage the trasfer case motor. From what I,ve heard the solonoid unit is located behind the plastic panel that is under the glove box and before the passenger side door. Moisture can build up in that area and ruin the solinoid unit over time. Check any fuses that have any thing to do with the 4x4. If the solonoid unit or fuses is not the problem, I would check the wireing to the electric transfer case motor and the motor itself. Good luck and God bless!

Posted on Oct 17, 2009

Testimonial: "Thanks for the info.. It actually turned out to be a rotten connector in the wiring harness just before the transfer case. I cut it out and re wired.."

sleprocks
  • 147 Answers

SOURCE: 2000 ford ranger super cab won't start clicking

Could be corrosion on the cables, I would clean both cables and try again. if no corrosion I would then look at the battery for correct voltage and fluid. batttery could be bad.

Posted on Oct 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Ford Ranger wont start or turn over.


What is litre size of engine, automatic tranny or manual? Check the wiring circuits at the starter for voltage,use a test light, One circuit is hot all the time, the other circuit goes hot when starter relay is energized. Any testing at the starter make sure tranny is in park or neutral and the parking brake is set. The clicking noise may be the starter relay.

Nov 20, 2014 | Ford Cars & Trucks

1 Answer

Ford ranger electrical


Check the starting circuit fuses. Most likely its a bad starter. If you can easily get at it. Drop it out attach a ground line between the body of the starter and any clean metal under the car. Have someone look at the starter while you try starting. If it does noithing when you turn the key to start, its time for a new one.

Jul 29, 2014 | 2003 Ford Ranger Regular Cab

1 Answer

Under dash fuel switch


The clicking is likely due to a low/defective battery or loose corroded battery cable ends. You can have it tested by any Autozone, Sears or Sams club near you for FREE!.

Oct 31, 2012 | Cars & Trucks

1 Answer

2000 ford ranger super cab won't start clicking


Could be corrosion on the cables, I would clean both cables and try again. if no corrosion I would then look at the battery for correct voltage and fluid. batttery could be bad.

Oct 26, 2009 | 2000 Ford Ranger SuperCab

1 Answer

I have Ford Ranger Supercab 2001. The 4wd does not engage.. clicking sounds from under the dash board. Please help :)


When you turn the dial to 4 wheel drive it controls a solonoid unit that then controls the electric motor that shifts the trasfer case to 4X4. The clicking sound that you are hearing is probobly the solonoid unit (4x4 control unit) engaging or trying to engage the trasfer case motor. From what I,ve heard the solonoid unit is located behind the plastic panel that is under the glove box and before the passenger side door. Moisture can build up in that area and ruin the solinoid unit over time. Check any fuses that have any thing to do with the 4x4. If the solonoid unit or fuses is not the problem, I would check the wireing to the electric transfer case motor and the motor itself. Good luck and God bless!

Oct 16, 2009 | 2000 Ford Ranger SuperCab

1 Answer

I HAVE A2000 FORD RANGER 4.0V6 AND IT WONT START I HAVE CHECKED ALL FUESE WITH A METER CHANGED BATTERY STARTER IGNITION AND ELECTIC IGNITION BOX UNDER STEERING COLOUM EVERY THING COMES ON BUT WONT START OR...


There are braided metallic bands that help ground your engine. They are usually located at the back of the engine going to the firewall. If they are frayed or disconnected in any way it could be causing the starting problem. Check all your wires for loose connections or corrosion. Hope this helps. God bless!

Sep 30, 2009 | 2000 Ford Ranger SuperCab

2 Answers

Truck wont start after sitting for year


you need to try a new battery sounds like your battery has gone bad

Apr 23, 2009 | 1987 Ford Ranger

4 Answers

2005 Ford ranger sdtarting issues


Bad inertia switch, I just had the same problem.

Sep 17, 2008 | 1991 Ford Ranger Supercab

1 Answer

96 ford ranger will crank but wont turn over


Try pressing a fuel reset button located under passenger side dash,far right side. I believe this is a rollover saftey switch that shuts the fuel off.

Jun 24, 2008 | 1996 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

243 people viewed this question

Ask a Question

Usually answered in minutes!

Top Avanti Experts

Berlyn Reed
Berlyn Reed

Level 3 Expert

486 Answers

Ilia Bichin

Level 2 Expert

171 Answers

Are you an Avanti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...