Question about 1993 Ford Festiva

1 Answer

The fuel cut out has activated when i changed the ignition.how do i fix it,the car is a 1995 ford fiesta.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 708 Answers

There will be a button either under the dash on the passenger side or in the trunk typically on the drivers side.

Posted on Jun 26, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to deactivate alarm on a 2014 ford fiesta ?


Dealer only sorry ,but try the fuel cut off switch its under the bonnet ,about a inch square with a red rubber top push it down again and it will click

Jul 26, 2014 | 2014 Ford Fiesta

1 Answer

Ford fiesta ignition key will not turn


Have you tried another key ?
You may need a new key from the dealer cut from code if you only have the one.

Jun 28, 2012 | Ford Fiesta Cars & Trucks

1 Answer

Ford Fiesta 1989. Starting problems


Hello! i would suspect the Carb fuel bowl vent level clearance..

Mechanical Fuel Bowl Vent Lever Clearance Adjustment

Secure the choke plate in the wide open position...
Turn ignition key to the ON position to activate the Throttle Position Sensor (TPS)... Open the throttle so that the TPS plunger extends fully.
Verify that the throttle is in the idle set position (contacting the TPS plunger)... Measure the clearance of the fuel bowl vent arm to the bowl vent actuating lever. ..Fuel bowl vent clearance (dimension A) should be 0.03 in. (0.76mm)...See diagram below...Guru...saailer


5_6_2012_1_29_48_pm.gif

May 06, 2012 | Ford Cars & Trucks

1 Answer

I have just changed the batteries in my key fob for my P reg. ford fiesta but it won't open the doors


Programming
When
Key batteries completely discharged. Key batteries not replaced within 15 seconds. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Turn ignition switch to position I. Wait approximately 10 seconds. Ensure clock LED illuminates.
NOTE: LED illuminates for approximately 5 seconds.
Switch ignition OFF and remove key, while LED illuminated. Programming mode activated for approximately 20 seconds (LED illuminated). Proceed as follows: Point key at receiver (located near interior lamp). Press and hold unlock button Fig. 1 [1]. After approximately 1 second key LED will flash once [3]. Press lock button 3-5 times Fig. 1 [2]. Release unlock button Fig. 1 [1]. Continue to point key at receiver until LEDs in clock and key have flashed 5 times. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode and extinguish clock LED: Switch ignition ON and OFF. Wait approximately 20 seconds

Jan 16, 2010 | 1995 Ford Escort

1 Answer

Car cut out while driving and engine now rattles


change distributor cap and rntar button

Aug 06, 2009 | Ford F Cars & Trucks

1 Answer

Ford Fiesta shakes while driving....


it sounds like the vacuum lines are off or it needs a tune up and a drive belt put some STP gas treatment in the gas tank make sure the car has a half a tank and if the car starts running better change the fuel filter

Jan 18, 2009 | 1997 Dodge Intrepid

5 Answers

Engine cut-out


I am pretty sure and would look into the ECM and i know for sure that the ecm is over heating and it breaks the circuit to your fuel pump relay please keep me posted

Nov 11, 2008 | Ford F Cars & Trucks

1 Answer

Fuel cut off light


there is a fuse and a relay that need to be checked they are located in the fuse box under the hood. if there is a cut off it will be located in the trunk behind the fabric.

Jul 29, 2008 | 1995 Ford Probe

Not finding what you are looking for?
1993 Ford Festiva Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...