Question about 1996 Ford Mustang

1 Answer

I have a 1996 Cobra SVO SVT that the high speed

I have a 1996 Ford Mustang Cobra SVO SVT that the high speed cooling fan stopped coming on. The low speed fan works fine. If I run a jumper wire to the high speed fan it runs also. It is supposed to run when the air conditioner is on however it does not. I cannot figure out why it doesnt. Can someone help me out here?

Posted by on

  • 4 more comments 
  • jamez202 Jun 26, 2009

    The haynes manual that I have doesnt tell me where the relay is. Can you?

  • jamez202 Jun 26, 2009

    If the relay is in the power distribution box by the battery I tested all 3 relays in there with and without juice applied and all 3 check out good

  • jamez202 Jun 26, 2009

    A/c works great. I tested the 3 relays in the power distribution block and they all test fine. With and w/o power.

  • Anonymous Mar 18, 2014

    Remove ingeng

  • Anonymous Mar 18, 2014

    what is low speed fan not working

  • Anonymous Mar 18, 2014

    high speed fan works fine, low fan does not
    \ why????????????

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 115 Answers

Ok. so you know the fan is good. switch out the relay for that fan with another same relay and check with the a/c button.

Posted on Jun 26, 2009

  • 1 more comment 
  • Aaron Murchison
    Aaron Murchison Jun 26, 2009

    does your a/c work? you'll have to trace to wires back from the fan. there may be a break in the wires or a loose connection. to test the relay you have to aply power the the switch side then check for continuity between the other terminals. if the is a fan relay there you could use a jumper wire in place of the relay and it should come on. the relay will have a map on the side showing which terminals activate the relay and which ones are the switch.

  • Aaron Murchison
    Aaron Murchison Jun 26, 2009

    so you're down to tracing back the power wire from the fan and checking for power along the way.

  • Aaron Murchison
    Aaron Murchison Jun 26, 2009

    sorry just thought you should also check the ground wire. jump just a ground wire from the battery to the fan or check continuity from fan ground to body.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need firing order diagram for a 1995 ford mustang cobra svt with a 302 liter engine


1995 Ford Mustang 4.6 liter DOHC V-8 Cobra

821039a.gif

Hope this help (remember rated this). Good luck.

Jun 02, 2010 | 1995 Ford Mustang

2 Answers

The cooling fan on my 2001 ford escort SE will not work normally


Check the coolant temperature with the car stopped. At idle with the hood up keep the thermometer in the coolant. Confirm if the coolant is not overheating but the engine is!!

Run the A/C keeping the thermometer in the coolant and allow the fan to kick on.

If with the A/C on the engine doesn't overheat then it confirms that the low speed on the fan motor is not working. Read the description of the Taurus where the low speed is used for normal operation when temperature is required but the high speed is activated when the A/C is on. The circuit is simple.

In your case the low speed has to be activated for the A/C to go into the high speed. The fact that the high speed is working and low speed is not indicates the low speed of the fan is defective.

Other problems such as the thermostat or plugged cooling system(radiator clogged) could be the root problem!

Hope this helps?
2010-09-05_004249_03_focus_cooling_fan_resistor-3xudhdxidxafwe4mdbsnm14c-4-0.jpg

dual_speed_fan_diagram-3xudhdxidxafwe4mdbsnm14c-4-2.jpg

Jun 24, 2017 | Ford Escort Cars & Trucks

1 Answer

What high performance manifolds fit a 1997 svt mustang please help


flow tech im not sure size or is that what your looking for

Apr 11, 2010 | 1997 Ford Mustang Cobra

1 Answer

1999 Ford Mustang SVT Cobra not starting


maybe you should put the fuel injector in the car. Hope this helps

Jan 12, 2010 | 1999 Ford Mustang Cobra

1 Answer

How do I replace a 1999 mustang cobra ignition


A '99 Cobra has 8(!) Coils. This is calles a "Coil on Plug" Ignition System.
http://www.steeda.com/products/msd_coil_on_plug_high_output_coils.php


Oct 11, 2009 | 1999 Ford Mustang Cobra

2 Answers

Air cool when driving, when idling gets warm and car overheats


Take a look through your front grill and see if there is alot of bugs,dirt,etc. blocking the cooling fins of the condensor and radiator. If so try rinsing them with a water hose, or air pressure. Some cleaners work well also,like " Simple Green " or gunk degreaser. Catch the fluid in a container and dispose of properly.

Jul 29, 2009 | 1998 Ford Mustang

4 Answers

83 mustang gt


In a 83 MUSTANG GT the correct answer is BOTH. As a 5.0L and a TURBO CHARGED 4 cyinder were offered.


1983 Mustang GT
  • Engine:
    • 5.0L horsepower increased to 175 HP when 4V carb replaced 2V carb from 1982 (Holley 4180C series).
    • Exhaust system was revised (less restrictive).
    • 4-speed SROD was only transmission available until early December 1982. In December, new 5-speed T5 became standard GT transmission (4-speed remained on option list).
    • Block and crank were revised to accomodate a 1-piece rear main seal in December 1982.
    • The new "Turbo GT" with a turbo charged 4 cylinder engine was available beginning late in the model year - 145 HP and featured the same suspension and other features of the V8 Mustang GT.

Jun 02, 2009 | 1983 Ford Mustang Hatchback

1 Answer

No high speed cooling fans 1996 honda accord low speed only


High speed fans only come one for high temp or high a/c pressure. Will be hard to tell if they work on high.

Mar 27, 2009 | 1996 Honda Accord

Not finding what you are looking for?
1996 Ford Mustang Logo

Related Topics:

309 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...