High speed engine check light comes on code p0755
There is-a row of. Solonoids four of them togearher
the one you need is the second one also xk wiring
gskt and 4. Quarts of trans fluid the dealer might sell all
4solonoids togeather call and ask also it is solomoid. B
This is a fault with auto trans shift solenoid B. It could be low or dirty fluid, the electrical connector, or the solenoid itself. First try draining and refilling the trans fluid, even twice over.
SOURCE: Sluggish transmission engagement. Traveling at
changing your VSS is easy , the hardest part is finding it...look around the housing near your CV axles..the differential in there near there is a 8 or 10mm bolt holding it in witha wire connector on the end...if you pull it out you will see a plastic gear on the end of the sensor.... YOU CAN DO IT!!!!
SOURCE: engine check light on
2002 toyota camry (4cyl) engine check light come on when I run high speed 80mph
SOURCE: I have a 1996 Toyota Camry. the engine light
that code is not a code for a toyota camry, please check the code again. for futher help please call 419 689 1114
SOURCE: CODE P0755 ON TOYOTA CAMRY
DTC P0755 - Shift solenoid valve B
This warning is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Gears will then be shifted to the optimum position.
The P0755 code is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve.
Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission will not shift gears.
Possible causes:
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shift solenoid B valve
- Shift solenoid B valve harness or connectors
- Shift solenoid B valve circuit is open or shorted
When the a transmission solenoid is malfunction, in most cases the problem is not the electrical part of the solenoid; the problem is foreign material obstructing the mechanical function of the solenoid or the flow of the fluid through the transmission valve body. If the transmission fluid is very dirty, it is recommend changing the transmission fluid and if possible removing the transmission pan for further diagnosis. Excessive debris or metal particles on the transmission pan could be an indication that there is a transmission mechanical failure and that the transmission will need to be rebuilt or replaced.
Additional test details could find in this link about Repair/05/2011ne09/cip0755 (pdf)
Hope this helps (remember to rate and comment this answer).
SOURCE: P0755 P0758 P1346 what are these codes in a toyota rav4
P1346 Variable Valve Timing Sensor / Camshaft Position Sensor Circuit Range / Performance, but I am not sure.
You can get a Mini VCI to clear code, it is widely used in Toyota cars. and really a cheap tool.
404 views
Usually answered in minutes!
×