Question about 1999 Jeep Grand Cherokee

1 Answer

It won't sometimes it starts others then the so=ame thing

Did not start last night so i cleaned battery cables then it worked fine all day then it did not start again today it did not start so trief the battrry thing and did not start it so weird like it takres a few seconds ro start sometimes then does

Posted by on

  • rbarsom Jun 26, 2009

    um whats the cranck sensor where do i find it same thing again i left it oevernight and it started right up this morning

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Check the wires going down to the cranck sensor. Wiggle the wire then try to restart.

Posted on Jun 26, 2009

  • carkrazee Jun 26, 2009

    The cranck sensor is located at the back of the engine. If the engine is a V8 the sensor is on the passenger side, if inline 6 it is on the driver side.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Starter problems, Suggestions???


Starters tend to fail intermittently. Yes, if it started after a "whack", I woul suggest replacing your starter. Make sure all connections are tight and of course clean terminals and cables.

Sep 03, 2016 | Cars & Trucks

1 Answer

2001 Mitsubishi aileron won't start turn over nothing lights work n eavrything already have checked the starter it's fine what other thing could it be


I HAVE AN ECLIPSE. Sometimes it the little stuff so lets try something.
  1. Your lights work ok but no start that's because your lights do not need 650 cold cranking AMPS to work.so:
  2. disconnect your battery cables. clean the posts and cables were they go over the posts till there silver. Use wire brush.
  3. reconnect and make sure they are tight.
  4. check for 12 or more volts at battery
  5. try a start
  6. if not clean and tighten other ends of cables and other wires to solenoid.
  7. try a start
  8. if not check for power 12 volts at the starter
  9. if not check the line power from the key
Hope this helps Mike

Mar 02, 2016 | Mitsubishi Cars & Trucks

1 Answer

Why does my 2007 Corvette have no power. was starting fine, turned engine off now has no power ?


battery old and just went flat? they have to fail sometime

left your lights on?

electrical fault causing battery drain

Sep 01, 2014 | Cars & Trucks

1 Answer

2002 yukon wont start drove it allday yesterday and last night .woke up headed to to work wouldn't start tried jumping it still kno start replace battery and still wont start


Is the starter engaging when you jump start it? You say you replaced the battery, is the cable ends clean? If the starter is engaging you have other problems, if its not then check out the starter/cables. Good luck!

Dec 04, 2013 | Cars & Trucks

1 Answer

2004 Ford Escape - Nov 02, 2013 (7:22 pm) Drove


Remove battery and clean the posts of corosion , also the contacts from green gue , sand the contacts , re install . Clean main contact to starter also .

Nov 03, 2013 | Ford Escape Cars & Trucks

1 Answer

05 Kia sorento won't start replaced battery two


Do you have fuel pressure and spark to the plugs ?

Jun 30, 2013 | Cars & Trucks

1 Answer

96 GMC Yukon won't turn over


Thats what i would try and if that dont help, maybe check the connections at the starter.

Feb 18, 2013 | 1996 GMC Yukon

2 Answers

My car was running fine all day yesterday until that night. I cut it off and it wouldnt start back up. Finally i got someone to give me a jump off and it worked but the dash lights kept on dimming in and...


You, my friend have a flat battery.

However, replacing the battery will not fix the problem, the battery is just a symptom, just like having cough syrup won't fix a cold, it will ojnly make your throat feel better.

What you need to do, is replace the battery, then get a multimeter, and check the voltage of the battery when the car is running at idle (in park/neutral), it should be 13.2-14.4v. If below this, im suspecting 12.0v or below, then you will have to have your charging system (alternator) checked.

Jun 11, 2010 | 2003 Pontiac Sunfire

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...