Question about 2000 Dodge Caravan

1 Answer

Window motor inside door panel stopped working how do i get the inside door panel off.

Posted by on

  • terryrvogel Jun 26, 2009

    Will need to try it before I know if it solved the problem.



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 578 Answers

Remove the screws that hope the door panel and unplug all the wiring and you will see the screws that hold the motor remove them and take the motor out at the bottom

Posted on Jun 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

99 plymouth voyager window not working. both front windows quit at different times but they slowly stopped working. wondering if there is a relay that may have gone bad?

If both front windows stopped working at different times ,wouldn't be a relay . Besides ,their are no relays involved in the operation of the power windows . As old as your vehicle is , i would expect the motors to be bad or regulator problem or broken wires inside the flexboot from the body to the door . Opening an closing of the doors a bunch of times can causes this . Taking the door panel off an checking for B+ voltage to the window switches an the motors is the way to find the problem .
How To Diagnose your Power Window Problem Is the Switch or motor bad

Apr 04, 2018 | Plymouth Cars & Trucks

1 Answer

Pontiac Montana 2004 drivers side power window stopped. Will not open. Can't find right fuse. Where is it?

It's not a fuse problem , all the other windows work ? One Circuit breaker powers all windows . Probably the window regulator is bad or the switch or the motor . Pull the door panel off the driver door an test the electrical circuits . Could also have wires broken inside the body to door flex joint (black rubber boot )
How To Diagnose your Power Window Problem Is the Switch or motor bad

Jul 30, 2017 | Pontiac Cars & Trucks

1 Answer


check for a broken wire inside the boot that runs from the drivers door to the body.

Dec 29, 2013 | 1995 Lexus GS 300

1 Answer

My passenger side electric window has stopped working, doesnt work when operated from passenger or drivers side. Have changed the switch what else could it be

The next step of course would be the window motor and or the window motor harness inside the door. Pull the door panel off and check to see if the motor gets battery power when the switch is operated.

Jun 25, 2012 | Cars & Trucks

1 Answer

My window just stop working

if it is only driver`s window that stopped working, then it won`t be a fuse related problem. Wiggle the main switch on your door. Could be the switch or possibe window motor or regulator. You will have to remove the inside door panel to diagnose motor or regulator..

Feb 17, 2011 | 1996 Oldsmobile Aurora

2 Answers

Same problem, key switch and dash switch don't power window

you will need to remove the inside panel on the door and unbolt the track or motor to release the window enough to lower it so you can open the door. Then test for a pwer and ground at the connector. If all is good you need a new moter.

Aug 14, 2009 | 1991 Ford Bronco

1 Answer

My drivers side electric window stop working 2002 ford sport trac. how do you change the motor

To remove the door panel, phillips head door screws should be removed, and the panel should slide up. Next, unbolt the window from the regulator and remove the window from the door. Then unbolt the regulator. The regulator and the motor have to be removed together. The motor will be mounted to the door on the inside. There should be three screws or nuts (10mm) holding the motor in. Remove motor and regulator. Reverse to reinstall.

Jul 11, 2009 | 2002 Ford Explorer Sport Trac

1 Answer

Power window problem. engauges then disenguages

Section 01-11: Glass, Frames and Mechanisms 1997 Windstar Workshop Manual REMOVAL AND INSTALLATION Door Glass and Regulator, Power Windows Removal
  1. Remove front door trim panel (23942) and front door inside panel sound insulator (20394). Refer to Section 01-05 .
  1. Remove inside door belt weatherstrip.
  1. Remove front door window glass (21410) as described in this section.
  1. Remove two nut and washer assemblies attaching the window regulator equalizer arm bracket (23230).
  1. Remove four rivets retaining the front door window regulator base plate to door inner panel.
  1. Remove front door window regulator (23200) and front door window channel bracket (23288) from vehicle.
  1. Working on a bench, carefully bend tab flat to remove front door window regulator arm slides from front door window channel bracket.
  1. NOTE: Use care not to break tab; if tab is cracked or broken, replace front door window channel bracket. Make sure rubber bumper is installed properly on new front door window channel bracket, if replacement is made.

    Install new front door window regulator arm plastic guides into front door window channel bracket and bend tab back to 90 degrees.


NOTE: The front door window channel bracket and window regulator electric drive (23394) are installed into the vehicle as one assembly. The front door window channel bracket may be disassembled from the window regulator electric drive as described in Door Glass and Regulator, Power Windows .

  1. Install window regulator electric drive with preassembled front door window channel bracket into vehicle. Set the regulator base plate to door inner panel using base plate locator tab as a guide.
  1. NOTE: Two 1/4-20 x 1 inch bolts and two 1/4-20 nut and washer assemblies may be used as alternates for glass retention. However, torque must not exceed 4-7 Nm (35-44 lb-in). Equivalent metric retainers may be used.

    Install four rivets to retain front door window regulator to door inner panel.
  1. Install window regulator equalizer arm bracket.
  1. Lower front door window regulator arms to access holes in door inner panel. Install front door window glass as outlined.
  1. Install inside door belt weatherstrip.
  1. Adjust front door window glass to make sure it is properly aligned with glass run. Check window for smooth operation.
  1. Install front door trim panel and front door inside panel sound insulator. Refer to Section 01-05 .

    Door Glass and Regulator

Item Part Number Description 1 21410 Front Door Window Glass 2 23288 Front Door Window Channel Bracket 3 23394 Window Regulator Electric Drive 4 23230 Window Regulator Equalizer Arm Bracket 5 222A00 Front Door Glass Run Latch Side Retainer 6 N621906-S36 Nut and Washer 7 N800510-S36 Screw 8 23200 Front Door Window Regulator 9 W525172-S Rivet 10 W525175-S Rivet 11 — Wire Connector (Part of 14630 Wire Assembly) A — Tighten to 7-10 Nm (62-89 Lb-In)

Apr 13, 2009 | 1997 Ford Windstar

1 Answer

I have a F150 and the driver's window stopped working. THe motor makes noise but nothing moves the window. I've read posts about the trend with bad window parts. Am about to order the regulator, but wonder...

i wouldnt replace the motor if it is working it sounds like the window is off track inside the door take the panel off the door and see if its on track. if not u can get it back on track that way

Nov 27, 2008 | 2004 Ford F150

3 Answers

My drivers side window on my mini one has stopped working, When i press the button to lower it i can hear a faint clicking sound coming from inside the door panel.

When the same thing happened on my Mini Cooper (2001), I had to have the window motor replaced (cost approx £250).

Aug 07, 2008 | 2006 BMW Mini

Not finding what you are looking for?
2000 Dodge Caravan Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides