Question about 2002 Kia Spectra
Had the car scanned and i replaced the transmission control unit, the car worked fine for about thirty minutes and then started again, now the code reader says P-0758 shift solenoid B electrical? is this in the trany?? and can it be prchased?
The B shift solenoid is mounted internal to the transmission on the valve body. It can be purchased and replaced. However, if you are not familiar with the internals of an auto transmission I strongly recommend that you have a professional do the job for you. It's not a major job.
Posted on Jun 25, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Mar 25, 2017 | Cadillac CTS Cars & Trucks
The body control module (BCM)
The powertrain control module (PCM)
The BCM controls the voltage to the shift lock control solenoid through the shift lock control solenoid controlled voltage circuit. The following conditions must be met before the BCM will supply voltage to the shift lock control solenoid:
The ignition is in the ON position.
The PCM sends a class 2 message to the BCM indicating the transmission is in the PARK position.
The BCM determines the brake pedal is not applied according to the stop lamp switch.
When the ignition is in the ON position, the ignition 1 fuse supplies voltage to the automatic transmission shift lock control solenoid as the BCM supplies a ground to the control circuit, mechanically locking the shift lever in the PARK position as the solenoid energizes. When the brake pedal is applied, the BCM turns the ground of the control circuit OFF, de-energizing the shift lock control solenoid. The de-energized solenoid releases the mechanical lock allowing the driver to move the shift lever out of the PARK position. When the transmission is out of the PARK position, the shift lock control solenoid remains de-energized.
Your best bet is to take it to the dealer ,may have DTC'S
DTC B2707 Gearshift Unlock Circuit Low
The body control module (BCM) controls the automatic transmission shift lock control solenoid by providing a controlled ground to the automatic transmission shift lock control solenoid. The BCM utilizes a smart driver to monitor the voltage and current flow of the automatic transmission shift lock control solenoid control circuit. DTC B2707 will set when the BCM detects a short to ground when the solenoid is in the OFF state.
DTC B2708 Gearshift Unlock Circuit High
Did you perform the Diagnostic System Check - Vehicle?
Go to Step 2
Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
Jan 11, 2016 | 2005 Chevrolet Equinox
Jan 02, 2014 | 2001 Honda Odyssey
The engine and automatic transmission in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
Bottom line here it needs to be scanned to see what is going on, quit guessing.
Aug 25, 2012 | Cars & Trucks
Nov 04, 2011 | 2004 Mercury Mountaineer
Apr 07, 2010 | 1998 Pontiac Sunfire
Jul 22, 2017 | 1999 Mercury Sable
Jan 06, 2009 | 1993 Toyota 4Runner
1,061 people viewed this question
Usually answered in minutes!