Question about 1995 Ford Probe

Open Question

Where is the low pressure port for the AC on a 1995 ford probe GT?

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 1995 Ford Probe GT no spark

Along with above, you could also have a bad coil pack firing off too.

Posted on Dec 23, 2008

Ad
emissionwiz
  • 76846 Answers

SOURCE: AC low pressure port 2001 Ford Ranger 3.0L

not sure about the color, but the low press charging port is in the large AC line, the one that gets cold, the small line is the high pressure line.

Posted on Apr 23, 2009

emissionwiz
  • 76846 Answers

SOURCE: where is the ac low pressure port to recharge the

It is on or near the reciever dryer or shiny looking thing at the right rear of the engine compartment. You need gauges to correctly add refigerant as you can overcharge it.

Posted on Jun 25, 2009

  • 226 Answers

SOURCE: where is the low pressure ac port on an 1999 ford

If you find the big round silver thing (reciever/dryer) it is in it or in the same line nearby. Probably area of passenger side close to firewall. The low pressure side is the larger of the tubes.
Lee

Posted on Jun 02, 2010

  • 19 Answers

SOURCE: i need timing belt digrams for a 94 ford probe gt ...

moz-screenshot-1.pngAlign the engine timing marks as follows, then install the belt.

ae00695.gif

f446780.gif
Once the belt is routed, as shown below, install the indicated pulley last, then pull the pin out of the hydrualic-tensioner.
cc4ecb7.gif

Posted on Jun 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

AClow side port 1995 ford windstar


The low-side port will be directly adjacent to the receiver/dryer near the firewall.

May 20, 2015 | 1995 Ford Windstar

1 Answer

Where is the low side ac port on a 1994 ford probe


The high side port is located just before the receiver driver, which then feeds the evaporator inside the car.
murf427

Jul 31, 2012 | 1994 Ford Probe

1 Answer

AIR CONDITION 1995 FORD PROBE


You have a leak that needs to be repaired FIRST

The pipe is frosted because the refrigerant is low
& boils off to soon

DO NOT ATTEMPT TO ADD ANY HAVE IT REPAIRED

Jun 15, 2012 | 1995 Ford Probe

1 Answer

WHEN TURNING THE KEY ON MY 1995 PROBE GT THER IS NO FUEL PRESSURE OR PUMP NOISE BUT CAR DOES RUN BUT STUMBLES AND HAS 26LBS. OF PRESSURE.


No Fuel Pressure--BUT you have 26# ?
No Pump Noise--BUT it runs ?

Is the fuel filter fairly new
Did you check out the pressure regulator,
MAF & TPS Sensors?

Mar 08, 2011 | 1995 Ford Probe

2 Answers

Where is the low pressure AC port in my '98 Ford Explorer?


LOW pressure port should be next to dryer,,pass. side

Aug 10, 2010 | 1998 Ford Explorer

1 Answer

Can't find low pressure recharge port for AC 1997 buick skylark


Where is the AC recharge port located on 1995 Buick Skylark

Jul 02, 2009 | 1997 Buick Skylark

1 Answer

2000 ford taurus low end ac valve


please rate as fixed if this helps you.

The low pressure service gauge port valve is located on the evaporator to accumulator/drier suction line.


The evaporator to accumulator/drier suction line contains low pressure refrigerant gas and is equipped with a serviceable low pressure A/C charge valve port.

Apr 28, 2009 | 2000 Ford Taurus

2 Answers

1995 Ford Probe GT no spark


Hi is your Probe a 2.5cc 24valve.If it is then you may need to check the CPS(crank position sensor) All the best.Phil

Aug 17, 2008 | 1995 Ford Probe

1 Answer

Which port to use to recharge AC on 1995 For Windstar?


I just got done recharging my a/c in my 1995 ford windstar and it was the low pressure port it is the smaller port for the recharge kit to fit on.

Jun 08, 2008 | 1995 Ford Windstar

Not finding what you are looking for?

Open Questions:

See all 1995 Ford Probe Questions

1995 Ford Probe Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...