Question about 2003 Jeep Liberty

Open Question

My Jeep Liberty has a vibration that occursbetween 38 to 54 mph,

My Jeep Liberty has a vibration that occurs between 38-54 mph, it goes away in the summer. It happens in 4 wheel drive and 2 whell drive at the above speeds

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
AviatorF18
  • 29 Answers

SOURCE: Noise and vibration above 50 mph

Sounds like front differential or front drive axle issues. Check the front differential gear oil then take er' to the dealership before you end up spending a bunch of $. Most people change their oil frequently in the engine but forget about flushing the transmission fluid and changing oil in the front and rear differentials. I have three Ford 4X4s. Two which really get used hard. The 93 has 311K miles and still runs excellent. Trans and differentials get a fluid change every 25K miles and moble one synthetic engine oil changes every 5k miles.

Posted on Jan 25, 2009

Ad
  • 1 Answer

SOURCE: 4 wheel drive problem on Jeep YJ

you can also check the 4 wheel drive vacuum switch on top of the transfer case...got mine for 10 bucks from parts store...fixed the problem

Posted on Jan 26, 2009

  • 6982 Answers

SOURCE: loud vibration on 2005 jeep liberty when under load.

Sounds a lot like a wheel balance problem, Does vibration go away over 55? In checking driveshaft joints...If you looked at them with the vehicle in park with the wheels on the ground, the shaft is "loaded" and cannot be correctly checked. To do this properly, vehicle should be in neutral with both rear wheels off the ground. Sometimes a joint can appear to be tight but still be bad. Check for traces of powdered rust around the rubber boots right where the end caps meet the cross on the inside. Any rust there indicates lack of grease and the likelyhood that the joint is frozen.
Check both balance and joints. Good luck.
Don't forget to rate my answer after you find the problem.

Posted on Mar 27, 2009

  • 1 Answer

SOURCE: my 2004 jeep liberty starts to shimmie around 50 mph, what's that

I had the same problem and the only thing I did was have the wheels aligned for about 80$ and that fixed the problem.

Posted on Apr 28, 2009

SOURCE: I have a 2005 jeep liberty and it vibrates at 60k from the front

Try checking the cross joints on the prop shafts.

Posted on Oct 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Vibration at 45 mph +


Try having the front wheels balanced and tracked .

Jan 29, 2018 | Cars & Trucks

1 Answer

2002 Jeep liberty 4wd vibrates when accelerates above 60mph and when down shifting it vibrates and goes away. any ideas?


no idea at all, we cant drive it.
is it drive line vibration or just engine misfire.
we can ever guess that, it's to be experienced.
why as the bind, deaf and , absent.?
why not ask your service this.
all machines will vibrated, some normal some abnormal.
from as simple as tire out of balance or falling off car
to simple engine misfire.
and more, there are 4000+ parts on the car, of which any can get loose, or wear out. and vibrate.
in 2wd or 4wd or both
get the car serviced like 99.9% do today
some tests are dangerous,for sure noise only rolling... yah.
we have special tools to find them electronic, stethoscopes.

Mar 04, 2017 | 2002 Jeep Liberty

1 Answer

There is a noise and vibration, almost like an engaged ABS. It pulses and has a deep vibration, it does not sound like grinding and it is only present when coasting or braking. It's completely gone when...


Could be u-joints. Play goes away under Torque (accelerating) and returns when parts shift (unload) from Torque like coasting or braking.

Transmission or Torque converter not disengaging, hanging up in overdrive.

Oct 16, 2013 | 2005 Jeep Liberty

1 Answer

1997 BMW 528i. 158,000 miles. Get severe vibration/noise from transmission tunnel/driveshaft/floor when I asccelerate hard through 20 mph. This goes away at 24 mph and does not reoccur at any other...


Its possible that the drive shaft has something on it causing this vibration for example I accidentally sprayed under coating on part of my drive shaft and the vehicle did exactly what you describe until I got it scraped off. Additionally if its cold where you are ice can freeze on one side and cause this issue as well.

Feb 26, 2018 | Pro-Fit Cars & Trucks

3 Answers

My jeep liberty started vibrating a little at 40-55 mph and then if you let off gas it stops? is it safe to drive?


Have the tires checked for balance and out of roundness.
Probably it's ok to drive if the vibration doesn't throw the driver off.

Aug 16, 2010 | 2002 Jeep Liberty

1 Answer

Oscillating vibration around 60-70 mph in 6th gear


sounds like a cv joint to me. That is what usually occurs when one is showing wear. C.V joints usually wear out between 80,000 and 120,000 k.m.

Oct 14, 2009 | 2007 Mazda Speed 6 Sedan

1 Answer

My jeep rattle's/vibrates and it sounds like a truck when you let of the gas.


check motor mounts defective ones can cause engine to vibrate

May 25, 2009 | 2006 Jeep Liberty

3 Answers

Loud vibration on 2005 jeep liberty when under load.


Sounds a lot like a wheel balance problem, Does vibration go away over 55? In checking driveshaft joints...If you looked at them with the vehicle in park with the wheels on the ground, the shaft is "loaded" and cannot be correctly checked. To do this properly, vehicle should be in neutral with both rear wheels off the ground. Sometimes a joint can appear to be tight but still be bad. Check for traces of powdered rust around the rubber boots right where the end caps meet the cross on the inside. Any rust there indicates lack of grease and the likelyhood that the joint is frozen.
Check both balance and joints. Good luck.
Don't forget to rate my answer after you find the problem.

Mar 27, 2009 | 2005 Jeep Liberty

2 Answers

Vibration in a 91 Jeep Cherokee Laredo


is there any play in the transfer case output shaft

Jan 06, 2009 | 1991 Jeep Cherokee Limited

Not finding what you are looking for?
2003 Jeep Liberty Logo

Related Topics:

569 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...