Question about 1997 Jeep Grand Cherokee

1 Answer

O2 sensor location for jeep cherokee - 1997 Jeep Grand Cherokee

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

There are three one on each side if it's a v6 look on the side of the engine you will see two to 4 wires coming out of the exhaust pipe, then after the catalytic converter under the car there is a after cat o2 sensor.

Posted on Jun 25, 2009


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 10 Answers

SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997

left rear of engine block,on transmission bell way from top under brake booster use a wrench,

Posted on Jun 13, 2009

  • 17970 Answers

SOURCE: where to replace coolant temp sensor for 1998 grand jeep cherokee

Check this image...

b33c4b0.png the Section ZJ-Secc-8D-Ignition-Systems (page 5, fig. 10 and 11).

Good luck.

Posted on Sep 07, 2009

  • 285 Answers

SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy

it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps

Posted on Sep 23, 2009

Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "

  • 17970 Answers

SOURCE: need to find where o2 sensor is located on jeep

You have one O2 sensor, this is the location...


Also can check your 1993 Grand Cherokee Repair Manual

Hope this help (remember rated this), good luck.

Posted on Feb 08, 2010

  • 79865 Answers

SOURCE: IAT sensor location

here is a picture


Posted on Mar 09, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Location of bank 1 sensor 1 o2 sensor 0n a 6 cylinder jeep grand Cherokee laredo

bank one is left side top of engine standing looking at it , O2 sensor is located on exhaust manifold there is one on each manifold (right-left)

Sep 29, 2016 | Jeep Cars & Trucks

1 Answer

Need the location for replacement of o2 sensor bank 1 sensor 2 on a 2004 jeep grand cherokee

O2 sensors are in the exhaust pipes, bank one is on the side with cylinder 1 and sensor two is after the catalytic converter.

Sep 29, 2013 | Jeep Cars & Trucks

1 Answer

Where are the 4 o2 sensors located on a 2004 jeep cherokee larado

I dont have adiagram fore this but you shoud find them in the manafolds and can get this codes from other problems.If it is saying too low or high I would look it too it

Apr 12, 2012 | 2004 Jeep Grand Cherokee

3 Answers

Where are the o2 sensors located on a 2004 jeep grand cherokee and what are they called?

Grand Cherokee oxygen sensor locations for 4.0 and 4.7 engines...



An O2 sensor is a galvanic battery that provides the PCM with a voltage signal (0-1 volt) inversely proportional to the amount of oxygen in the exhaust. In other words, if the oxygen content is low, the voltage output is high; if the oxygen content is high the output voltage is low. The PCM uses this information to adjust injector pulse-width to achieve the 14.7-to-1 air/fuel ratio necessary for proper engine operation and to control emissions.

The O2 sensor must have a source of oxygen from outside of the exhaust stream for comparison. Current O2 sensors receive their fresh oxygen (outside air) supply through the O2 sensor case housing.

Four wires (circuits) are used on each O2 sensor:
* 12-volt feed circuit for the sensor heating element
* Ground circuit for the heater element
* Low-noise sensor return circuit to the PCM
* Input circuit from the sensor back to the PCM to detect sensor operation

Hope helps (remember to rate and commene this)..

Feb 04, 2011 | 2004 Jeep Grand Cherokee

1 Answer

Need to find where o2 sensor is located on jeep gran cherokee 93

You have one O2 sensor, this is the location...


Also can check your 1993 Grand Cherokee Repair Manual

Hope this help (remember rated this), good luck.

Feb 08, 2010 | 1993 Jeep Grand Cherokee

1 Answer

Where are the O2 sensors located on a 2002 jeep grand cherokee Laredo?


Jan 09, 2010 | 2002 Jeep Grand Cherokee

1 Answer

O2 code p0152 how repair replaced the sensors [4]

The O2 sensor is located on the exhausts manifold, or/and on the cat. Converter. Some cars have two.

Also, for more details, can review the Jeep ZJ Service Manual ZJ-Secc-14-Fuel-System

Check here for Reset Codes.

Good luck (remember rated this help)

Oct 17, 2009 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

Related Topics:

425 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides