SOURCE: Wondering if I can put power windows and locks on this vehicle as it's not equiped with them.
Unfortunately no. The design on the interior of the doors is different and cannot accomodate the needs of the power window motor, track, glass, wiring etc.
SOURCE: How to remove disc brake rotor on a 1992 Ford Explorer 4-wheel drive
It should just pull off once you have taken the caliper off. It may be seized in place, if thats the case try spraying the back of it with some sort of penetrating oil, let it sit for a bit. THen put some heat on it if you have torches, or beat it with a hammer. Sounds kind of crude...but it works
SOURCE: replaceing a lock cylinder in a ford explorer with no keys.
The least damage would be caused by a locksmith. You could break more than the lock cylinder if you try to drill it out yourself.
SOURCE: how to replace a lock cylinder on a 1992 ford
Steps to remove and replace the lock cylinder To Remove the Lock Cylinder 1: Remove the cover UPPER/LOWER) from the steering column(usually 2 phillips screws in lower cover, directly behind the steering wheel. 2: Turn the key to the run position (the position before start). 3: Using a small diameter object (paper clip) slide the wire into the hole located underneath the ignition switch on the underside of the column. While pushing up on the pin in the hole, turn the key and pull outward. The tumbler should release and come out. 4: To replace, turn the key in the new cylinder to run. 6: Place the cylinder in the column where the old one came out. 7: Turn the key to the off position and the cylinder is now locked in place.
SOURCE: do i need to greas the auto locking hubs on a 1992
YES THEY SHOULD BE CLEANED AND LUBRICATED THE GREASE GETS STIFF AND WON,T LET THINGS MOVE FREELY
59 views
Usually answered in minutes!
×