Question about 1999 Dodge Durango

1 Answer

My 99 dodge durango shut off on my wife. she said that the engine light turned on and the engine just shut off. she said she tried to turn it back on, but the durango just started t shake. now when you try to turn it on the it will not turn. and the engine light stays on

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Check your PCM a very common issue among Durangos See if there is any type of error code in the odometer. If 'no bus' is shown it is your PCM the main computer and your looking at about $500-$800 to replace it. to get it started try unhooking the battery cable for a few minutes and then hooking it back up

Posted on Jun 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Will a bad pick up coil stop a 1999 dodge Durango from cranking


It wouldn't stop the engine from turning over while trying to start. But it can make engine not start or run poorly

Sep 12, 2015 | Dodge Cars & Trucks

1 Answer

1999 dodge durango rear hatch wont shut


pull handle open and take a screwdriver and open the latch. still not latching ? try spraying silicone lubricant or wd-40 on latch

Sep 25, 2012 | 1999 Dodge Durango

1 Answer

My 99 dodge durango has a 'no bu5' code on the mileage abd it wont start at all. how do i fix this?


No bus message on the instrument cluster mean's there is a serial data bus problem . All the module's (computers) on your vehicle are connected on the CCD data network . They share information on the network . A shorted bus wire , a module malfunctioning an bring down the network can cause modules not to send and receive data which would cause a no start .
CCD Chrysler Collision Detection Data Bus
008 Chrysler CCD Communications

Nov 06, 2017 | 1999 Dodge Durango

1 Answer

2000 dodge durango will not start


remove and clean your battery connectors. Check to make sure they are tight. Often the lights will work but there is too much resistance to operate starter. If this is good have the battery checked. It should measure 12.6 to 12.8 volts with a fully charged good battery with no load.

Nov 28, 2011 | 2000 Dodge Durango

1 Answer

1999 dodge durango dash lights are taking turns coming on security, abs, brake, check engine ect. had the battery replaced about 2 mos ago problem since. We did unhook battery to reset but still have...


This happened to me when we got our 99 Durango back from collision work. Looked like a light show at Disney. Check the ground wires on the fire wall . There are alot of them and you'll have to really look for them all but your car is doing exactly what mine did. The body shop missed 4 ground wires during the repair and it drove me nuts but once they were all back on it was fine.

Oct 14, 2010 | 1999 Dodge Durango

1 Answer

99 Dodge Durango runs hot,ac only out defrost, wheel issue


Check the thermostat, and clean or replace the idle air control valve, replace the ball joints, replace the plugs and plug wiresthis should correct the problem.

Jun 27, 2009 | 1999 Dodge Durango

2 Answers

The lights on my 2002 Dodge Durango started flickering, as well as the dashboard lights. The doors started to lock and un-lock themselves. And the back windsheild wiper went off by itself.


the first thing i would check is the ground cable from the battery to the engine and the strap from the engine to the frame, also check battery voltage with car running, if you need more help get back to me as i strive to be the best, please rate my fix Tkanks Ray battery voltage should be over 13.6 volts

May 04, 2009 | 2002 Dodge Durango

1 Answer

Engine shuts off


try the crank position sensor

Apr 14, 2009 | 2001 Dodge Durango

2 Answers

2005 Dodge durango shuts down.


I had a similar problem with 99 Durango.
Replaced PCM with refurbished "brain" from online Florida company and no problems since. You may want to google for refurbished PCM and call the guys who sell them -- they were helpful to me and my fix was 3 screws and < $300.00.

Mar 25, 2009 | 2005 Dodge Durango

2 Answers

99 dodge durango will not start


Check the fuel pump when you turn the key forward but dont crank it and see if you hear the fuel pump engaging. I hope this helps.

Andy

Jan 18, 2009 | 1999 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

Related Topics:

466 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

81285 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...