SOURCE: I need to replace the fuel filter on my 2003 GMC
ITS A SPIN ON FILTER, YOU NEED TO DISCONNECT THE WATER SENSOR ON THE BOTTOM OF THE FILTER, THEN USING A STRAP FILTER WRENCH LOOSEN THE FILTER AND SPIN IT OFF.
CHECK THE FILTER HOUSING TO BE SURE THE INNER FILTER SEAL ISN'T ON THE HOUSING AND CAME OFF WITH THE FILTER.
REMOVE THE WATER LEVEL SENSOR AND DISCARD THE SEAL.
INSTALL THE WATER LEVEL SENSOR ON THE NEW FILTER. USING A LITTLE GREASE ON THE INNER FILTER SEAL AND ON THE OUTER O-RING TO HOLD IT IN PLACE, SPIN ON THE NEW FILTER.
OPEN THE VENT ON THE UPPER SIDE OF THE FILTER HOUSING. PUSH DOWN ON THE HAND PUMP QUICKLY UNTIL THE FUEL IS COMING OUT OF THE VENT. CLOSE THE VENT AND PUMP THE FILTER PUMP UNTIL IT FEELS SOLID. AT THIS POINT START THE ENGINE. IF IT STALLS PUMP IT UP AGAIN AND RESTART THE ENGINE. IF YOU HAVE AN ASSISTANT THEY CAN PUMP THE FILTER PUMP WHILE THE ENGINE IS RUNNING AND QUIT WHEN YOU FEEL THE ENGINE IS NOT GOING TO STALL. ABOUT 10 TO 15 SECONDS USUALLY WORKS.
CHECK FOR LEAKS.
BEFORE STARTING THE ENGINE USE BRAKE WASH TO REMOVE THE FUEL SPILLED DURING THE FILTER REPLACEMENT. ALLOW IT TO DRY BEFORE STARTING THE ENGINE.
RATE ME PLEASE.
SOURCE: holes in the transfer case of a 2002 gmc duramax
well there are a few options, depending on the wear of your transfercase you can just replace the rear housing and install new pump clips from gm, jb weld and other bonding agents will not fix the problem but rather prolong it, I just pick up a reman this week for my own truck that was only$1100 great deal compared to junkyards
SOURCE: i have a 2003 gmc sierra duramax diesel and im in
The diagram is simple each glow plug is connected in a series circuit like this -0-0-0-0-0-0-0 that's a in-line 6 for a V-8 it would look like this
[-0-0-0-0
[-0-0-0-0
and the plugs would be hooked up on the back then if you follow the wire to the glow plug relay you will find that the relay has four wires one to battery one to the glow plugs one to the ignition switch and one to ground in the box. If you want you can purchase a manual for 5.99 on-line. and it covers the three fuse-able links for this system and the new Glow plugs available for this truck here is the web page. http://www.wiring-diagram.com/?gclid=CMuAvJ3Ql58CFQZfagod0jpAxQ
SOURCE: Excessive black exhaust on 2003 GMC Sierra Duramax Diesel.
This is what i would try (cheapest first) redexe/wyyns
injector cleaner,double dose,then i have put 1gal gas in 10gal diesel to increase burn temp (you may encounter a hot start problem temporarilly)then if still smoking, get a compresion check on the engine(this will tell you volumes)
by the way the NATO tanks put in 1/3 gas in diesel to stop it freezing in arctic conditions.any more than 1/3 can result in problems.
SOURCE: Injector 2 on 2004 GMC Duramax diesel. Electrical
Get an injector tester and put it on every injector to find the one that is not firing.
632 views
Usually answered in minutes!
×